Installation guide

ManualsBrandsFrigidaire Manualswall ovenOfficial Frigidaire gas wall oven

INSTALLATION AND SERVICE MUST BE PERFORMED BY

A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

If the information in this manual is not followed exactly, a fire or explosion may result

causing property damage, personal injury or death.

FOR YOUR SAFETY:

m Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other

appliance.

-- WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire department.

-- Installation and service must be performed by a qualified installer, service agency or the gas supplier.

l Additional Safeguards

• Do not install wall oven beneath the work counter.

• The flue charge shall not be located below the 36" level.

42 3/s"

37 3/8"

Electrical Outlet

Location for model

with lY_ oven

/ity

Electrical Outlet

Location for

- model with 2

oven cavities

_-_ T_

T 27"

Model with 2 oven cavities Model with 11/zoven cavity

Clearance for complete door opening:

• For model with 2 cavities allow at least 17 5/8".

• For model with 1Y2cavity allow at least 19 3/8". Figure 1

Drill a lY2" diameter hole

for gas hook up

<:xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx:_<:xxxxxxxxxxxxxxxxxxxxxxxxx:_

Model with 2 cavities 19 Y2" Min.

10" Min.

Model wi_ 1 Y2cavity 27 Y2" Max.

2 Y2" Min. 24" Min. 16 3A" 7 1/8" 22 Y2" 24" Min. 42 1/8"

37 Y2" Min.

1 Y2" Min. 24" Min. 20" 7 s/8" 22" 23 Y2" Min.

39" Max.

NOTE: Wiring diagrams for these appliances are enclosed in this booklet.

_ Recycledpaper Printed in Canada

PIN 318201550 (0003) Rev. A

English - pages 1-8

Espa_ol - p4ginas 9-17

Wiring Diagram - pages 18-20

Summary of content (20 pages)

PAGE 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information causing property damage, in this manual personal is not followed exactly, a fire or explosion may result injury or death. FOR YOUR SAFETY: m -- Do not store or use gasoline or other flammable appliance. WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance.
PAGE 2
Important 1, 2, 3, 4, Notes to the Installer Read all instructions contained in these installation instructions before installing the appliance, Remove all packing material and literature from the oven and broiler compartments before connecting gas and electric supply, Observe all governing codes and ordinances, Be sure to leave these instructions with the consumer, Important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference, Save these instructions for local
PAGE 3
2. Connect Oven Electricity to Gas Wall For personal safety, these appliances must be properly grounded. 3.
PAGE 4
. AdJusting Oven Oven Height (Model with 1 1/2oven cavity only) Remove and lay aside the lower vent decorative trim that is taped to the side or to the top of the oven The decorative trim will be fastened to the lower front of the oven after it has been installed in the cabinet There is a 1 Y2" height adjustment on models with extension panel (see figure 4). With this adjustment and a Y2" trim overhang, a unit can be installed in existing openings 37 Y2" to 39" high. Panel Oven Bottom Figure 5 5.
PAGE 5
B. Model With 2 Oven Cavities Insert appliance into cutout, The unit must be secured in place, Use the 2 screws provided in the miscellaneous parts bag, for mounting the appliance in the mounting holes on each side trim aside the central vent trim (figure Ca Remove Screw_:::_ 7), "]_ II It ",..% II B1 Vent Pipe 4"I,D, °D Pipe to be A.._II tight to flue ._.____11 Mounting Screws collar Figure 8 7.
PAGE 6
8. Connection A. Model BEFORE CONNECTING THE UNIT with to gas Remove all packing material and literature from wall oven before connecting gas and electrical supply to the appliance, If applicable, remove broiler or storage drawer by pulling drawer out to stops, Lift drawer front to clear stops and pull out, 1 Vz oven cavity (seefigure 9) Pressure Regulator Leak testing of the appliance shall be conducted according to the manufacturer's instructions, Valve Check for leaks.
PAGE 7
_ SMALL End Towards Using a Y2" wrench, turn down the adjustable spud which injects gas into the oven burner. Spud approximately 2Y2 turns until snug against the LP metering pin. Do not overtighten (see figure 1 3). 10. Natural For L,R Gas Convert the Pressure Regulator for use with Natural Gas (see figure 11) A. Remove the cap from the pressure regulator. B. Remove the plunger. C. Turn the plunger upside down with the enlarge end UP. D. Replace the plunger inside the regulator.
PAGE 8
Observe the ovenburnerflameto determineif it isright. It shouldbesteadywitha blueconeapproximately 1" andshouldnotextendout overtheedgesof baffle. For LPGas,thiswill mostlikelyoccurwhenthe air adjustment shutteriscompletely open(seefigure15). TurnOvenTemperature to 300°Fandallowovento cycle onandoff. Model and Serial Number Location The serial plate is located on the left side inner trim of the oven for the model with 1 Y2oven cavity and on the lower oven frame for the model with 2 oven cavities.
PAGE 9
LA INSTALACION Y EL SERVICIO DEBEN SER REALIZADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR ELI_CTRICO LOCAL. .EA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS Si todas las instrucciones de este manual no son observadas a la letra, se puede ocurrir incendios o explosiones que pueden causar dahos materiales, lesiones o la muerte.
PAGE 10
Notas importantes para el instalador: encima de la estufa o en la guarda posterior de esta. Los nihos pueden quemarse o lastimarse seriamente si se suben en la estufa para alcanzar estos objetos. • No guarde o haga uso de gasolina o otros vapores y liquidos inflamables acerca de este o cualquier aparato. Se puede resultar en incendios o explosiones.
PAGE 11
2. Conexion Electrica 3. Alternativa Como medida de seguridad personal, este artefacto debe conectarse a tierra correctamente. de construccion (Para modelo con I 1/zcavidades solamente) Instrucciones para instalar un horno de 1 Y2cavidades en una abertura existente para horno de 2 cavidades con dimensiones de 42 _/8" de alto por 22 Y2"de ancho. !Ir_l_j_rm_ Para su proteccion contra choques electricos este aparato ha sido equipado con un enchufe de tres paras con conexion a tierra apropiada.
PAGE 12
4. Ajustando la Altura Puerta del horno del Horno (Para modelos con I Vzcavidades solamente) Retire y ponga a un lado la rejilla baja de ventilacion que esta pegada a la parte exterior del panel del horno. La rejilla sera fijada a la parte de baja del frente del gabinete despues de que este haya sido instalado en el gabinete. Este modelos de horno cuenta con un ajuste de altura de 1 1/2" (ver figura 4).
PAGE 13
B. Modelo con 2 Cavidades Introduzca el artefacto en el recortado. El electrodomestico debe ser sujetado en su lugar. Utilice los dos tornillos provistos en la bolsa de piezas varias para montar el electrodomestico en los orificios de montaje a cada lado de! armazon del horno, por encima Capucha Remuevatornillo-,-_::::_ I [ de la puerta (figura 7). B1 tubo de ventilacion "_ 4" I.D. ",.% Tubopara A,..IIII Tornillos de fijar a salida -______U montaje de ventilacion Figura 8 7.
PAGE 14
Paraevitarqueel pilotoseapague(sipuedeaplicarse), cierretodaslasaberturasdelacavidaddelgabineteque encierrala unida,Tambiencualquieraberturaalrededor delassalidasdelserviciodegasdebenestarcerradosen el momentodelainstalacion, 8. Conexion A.
PAGE 15
9. ConversiOn Licuado A. Conversion B. Ajuste del orificio del quemador de Gas Propano/ (vea figura del regulador del horno 12) Pasador de presion Nota: No remueva el regulador de presion. Convertir el regulador de presion para que se pueda usar con Gas LP/Propano (vea figura 11) Si necesario, remueva al asador o el cajon de almacenamiento hallandolo hacia afuera hasta los topes, luego saque hacia afuera.
PAGE 16
10. Conversion de Gas Natural Para gas natural la entrada de aire debera estar aproximadamente medio abierta. Para gas LP la entrada de aire debera estar casi totalmente abierta. Convertir la unidad de Gas LP/Propano a Gas Natural, proceda de la siguiente manerar (vea figura 11) A. Remueva la tapa del regulador de presion. B. Remueva el desatascador. C. Gire el desatascador hacia arriba con el lado Demasiado aire haria que la llama se alejara del quemador.
PAGE 17
12. Verifique Asegurese de incluir el modelo, numero de serie y el numero o letra de lore que se encuentran en la placa, en todo pedido de partes o solicitud de informacion acerca de su horno empotrado. la operacion Refiera al Manual del Usuario que viene con el horno empotrado para las instrucciones de funcionamiento y el mantenimiento y la limpieza de su horno empotrado.
PAGE 18
CLOCK RELOJ THERMOSTAT TERMOSTATO nVEN LAMP SWITCH INTERRUPTOR LUZ DE HORNO CONNECTOR CONECTOR CONNECTOR CDNECTDR OVEN LAMP LUZ DE HDRNO @ OVEN LAMP SWITCH UNTERRUPTOR DE LUZ DE HORNO ® CLOCK RELOJ OVEN LAMP LUZ DE HORNn © ® ® @ DEN _LVO_ GVEN //J _ ____ OVEN IGNITER ENCENDID n DE HnRN n ENCENDI] [-_ CONNECTOR CDNECTOR CONECTOR OVEN VALVE VALVULA TE_DE L E _ HORNO THERMOSTAT HORNO CONNECTOR CDNECTOR CONNECTOR CONECTOR DE HORN.
PAGE 19
L N DOOR SW[TCH CONTROL BL/W- o o I O SEE BELOW FOR CONNECTION O5 O6 O 7 BROIL BAKE ---03 mcO--.. I 02 0 6 0 5 04 0-I 3R-I i --J BOARD LOCK 02 01 MOTOR NC Jl 0v- i SEE LEGEND V- I CON PROBE NO ,E4 BR E6(b LI Eg( _--- ,)E7 BA GND E] E_,) v-1 / W-1 R-I R-1 R-1 THERMAL CIRCU]T LEGEND BREAKER : BK-1 4_ W-I LATCH MOTOR r l BROIL IGNITER Ia I W-1 BL-I A.D.S. C NO BR --o_____v-o [ NC 0-1 BAKE Y-1 1 I GN [ TER W-I / w- 1 -0 _- RELAY COOL ] NG FAN
PAGE 20
OVEN LAMP SWITCH INTERRUPTBR DE LUZ DE HORNO CLOCK RELOJ THERMOSTAT TERMOSTATO L i i i i i i i i i i i i i : i i i _ IND. N CONNECTOR ;z CONNECTOR x CONECTOR CLOCK RELOJ _4_DOOR LAMP SWITCH INT. DE LUZ DE PUERTA ,F ........ -0_ LALMApMAPR A 0 :..... %_°!°____ i i J t i i i OVEN LAMP (I I; LUZ DE_I._ HORNO y_ L CONECTOR OVEN LAMP SWITCH INT, DE LUZ DE PUERTA i i i i i i ID OVEN LAMP LUZ DE HORNO IND. LAMP PILOTO LAMPARA BAKE VALVE VALVULA DE )_ DOOR LAMP SWITCH INT.