Use and Care

11
PROBLEM CAUSE CORRECTION
BEVERAGE CENTER OPERATION
Beverage Center
does not run.
Appliance is plugged
into a circuit that has
a ground fault interrupt.
Temperature control is
in the OFF position.
Appliance may not be
plugged in, or plug may
be loose.
House fuse blown or
tripped circuit breaker.
Power outage.
Use another circuit. If you are unsure
about the outlet, have it checked by a
certied technician.
See Setting the Temperature Control
section.
Ensure plug is tightly pushed into outlet.
Check/replace fuse with a 15 amp time-
delay fuse. Reset circuit breaker.
Check house lights. Call local Electric
Company.
Beverage Center
runs too much
or too long.
Room or outside
weather is hot.
Appliance has recently
been disconnected for a
period of time.
Door is opened too
frequently or too long.
Door may be slightly
open.
Temperature control is
set too low.
Door gasket is dirty,
worn, cracked, or
poorly tted.
It’s normal for the appliance to work
harder under these conditions.
It takes 4 hours for the appliance to cool
down completely.
Warm air entering the appliance causes
it to run more. Open doors less often.
See “DOOR PROBLEMS” section.
Turn control knob to a warmer setting.
Allow several hours for the temperature
to stabilize.
Clean or change gasket. Leaks in the
door seal will cause appliance to run
longer in order to maintain desired
temperature.
Interior
temperature is
too cold.
Temperature control is
set too low.
Turn the control to a warmer setting.
Allow several hours for the temperature
to stabilize.
BEFORE YOU CALL
Visit our web site at
www.frigidaire.com
1-800-944-9044 (United States)
1-800-265-8352 (Canada)