Complete Owner's Guide

22
OR7NEWModelEN-4.indd20 09.4.2811:46:25AM
CLEANING AND CARE
To avoid risk of personal injury or property damage, do
not operate oven hood without filters properly in place.
Cleaning the exhaust filters
The oven ventilation exhaust filters should be removed and
cleaned often; generally at least once every month.
1. To remove the exhaust ventilation filters, slide the filter to
the rear. Then pull filter downward and push to the other
side. The filter will drop out. Repeat for the 2nd filter.
2. Soak the ventilation filters in hot water using a mild
detergent. Rinse well and shake to dry or wash in
Do not use
ammonia. The aluminum
on the filter will corrode and darken.
3. To reinstall the exhaust ventilation filter, slide it into the
side slot, then push up and toward oven to loc
k.
Reinstall the 2nd filter using the same procedure.
Front
Rear
Surface lights
Ventilation
filters
Tab
Disconnect the power cord or leave the door open to deactivate the oven
during cleaning. Disconnect the power cord before replacing filters and lights.
Surface light replacement
To avoid risk of personal injury or property damage, wear
gloves when replacing the light bulbs.
1. Unplug the microwave oven or turn off power at the
2. Remove the cover mounting screws at both
light positions under the microwave.
3. Remove the LED light mounting screw.
7. Plug the microwave back into the power supply or
power back on at the main circuit breaker.turn the
4. Unplug the LED light from the harness, replace with
5304499540.
To order parts
5. Re-install LED light and mounting screw.
6. Re-install LED light cover and mounting screw.
call
800
-
599- 7569. Then reconnect the harness.
LED light
When re-installing mounting screw be careful
not to damage the LED light.
To order parts call 800-599-7569
5304478913
Vent exhaust filter part number
main circuit breaker.
LED light of part #