Installation Instructions

Installation Instructions
5
MOUNT THE MICROWAVE
OVEN (cont.)
8
7
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
packed with the microwave.
Tighten center
screw completely.
Install grease filters. See the Use &&&&and Care
INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
Unplug microwave oven or disconnect power.
NOTE: The charcoal filter is factory installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
For models without the recirculation filter access
Open the microwave door and remove the two
vent mounting screws ;located on top of the
microwave using a #1 Phillips screwdriver.
Charcoal
Filter
Remove the charcoal filter by pushing the
top of the filter inwards,then pull it forward
out from the unit.
Slide the top of the new charcoal filter into the
top of the filter cavity.
door,follow these steps to replace or install a charcoal
filter.
A4.
A5.
A 5.1
A 5.2
A 5.3
A 5.4
6
EN-12