Dimensions Guide
Accessories information available
on the web at frigidaire.com
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FGEW276SP 10/15 © 2015 Electrolux Home Products, Inc.
Specifications
subject to change.
Single Wall Ovens
FGEW276SP F / B 27" Electric
3"
Electrical
junction
box location
2" min.
1
1
/2"
min.
31"
suggested
distance
4
1
/2"
min.
required
27
1
/4"
min.
28
1
/4"
max.
Full base
required
to support
150 lbs.
27
1
/8"
min.
4" x 4"
opening
to route
armored
cable
24
7
/8"
min.
25
1
/4"
max.
23
1
/2"
min.
*
(critical
dimension)
2"-wide wood
spacers
(if needed)**
27" Single Electric Wall Oven w/Reversible Side-Swing Door
Frigidaire Gallery
*Critical dimension – MUST be applied
**For cutout height greater than 28
1
/
4
" add one 2"-wide
wood shim of appropriate height to each side of opening
under oven side rails. Lifting oven will hide larger cutout
opening at top and oven’s 1"-high bottom trim will hide
shims at bottom.
(Optional 3"-high bottom trim available
for cutout height greater than 29.)
29"
(includes
1"
bottom
trim)
24
7
/8"
27"
27
1
/4"
Allow at least
27
1
/4"
clearance
for reversible door
depth when open
Power
supply
location
(left
bottom
rear)
24
5
/8"
Single Wall Oven Specifications
•
Product Shipping Weight (approx.) – 130 Lbs.
•
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
•
Connected Load (kW Rating) @ 240 / 208 Volts = 3.7 / 2.8 kW
•
Amps @ 240 / 208 Volts = 15.4 / 13.4 Amps
•
Recommended Circuit Breaker – 20 Amps
•
Always consult local and national electric codes.
•
Minimum 27-1/4" clearance for oven door depth when open.
•
Suggested distance from floor is 31". Minimum required distance
is 4-1/2".
•
Minimum 23-1/2" deep cutout dimension is critical for proper
installation, to ensure that oven’s faceplate will fit flush against
cabinet front.
•
To adapt oven to fit cutout height greater than 28-1/4", add one
2"-wide wood shim of appropriate height to each side of opening
under oven side rails. Lifting oven will hide larger cutout opening
at top and oven’s 1"-high bottom trim will hide shims at bottom.
(Standard 1"-High Bottom Trim included.)
•
To adapt oven to fit cutout height greater than 29", optional 3"-High
Bottom Trim available.
•
Full oven base of solid plywood or similar material required,
capable of supporting 150 Lbs.
•
Base must be level and cabinet front must be square.
•
Single Wall Ovens are NOT approved to be used in stackable or
side-by-side installation.
•
Single Wall Ovens are approved to be used alone in under-counter
installation or beneath any approved Frigidaire® gas or electric
cooktop. (Refer to Gas or Electric Cooktop Installation Over 30" / 27"
Electric Single Wall Oven Specifications pages on web.)
•
Single Wall Ovens are approved to be used in combination with any
Frigidaire® Warmer Drawer. (Refer to model-specific Warmer Drawer
product page for Combination Installation Specifications.)
•
Single Wall Ovens are approved to be used in combination with
any Frigidaire® Built-In Microwave Oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
3"-High Stainless Steel Bottom Trim – (PN # 903114-901S).
•
3"-High Black Bottom Trim – (PN # 903114-9010).
•
10'-Long Armored Power Cable – (PN # 903056-9010).
In Progress
Waiting on Install Guide