Installation Instructions

5
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
1
The counter-top around the cut-out should be at and leveled (see
hatched area on illustration 1).
2
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the oor to the
top of the counter.
H1
H2
H3
H4
Illustration 1
Shave Raised Edge
to Clear Space for
a 31½" (80 cm)
Wide Cooktop.
1 ½" Max.
(3,8 cm Max.)
device: Remove and discard the two rear leveling legs, they are only in place to
solidify the unit during the transport.
5
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center
Illustration 2
To
successfully
install the
range, the
initial level
height from
oor to
underside
of cooktop
frame should
be at least
1/16" (0,16
cm) taller than
cabinet sides
as measured
in step 2.
of the cabinet cut-out.
6
Remove the protective channels on each side of cooktop (if
equipped).
7
The metal ange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT directly touch the countertop (see illustration 2) or
Metal
Flange
3
Level the range using the
leveling legs or leveling device
so that the height from the
oor to the underside of the
cooktop frame is greater than
the tallest cabinet measurement
by at least 1/16" (0,16 cm) (see
illustration 2).
4
Model equipped with leveling
8
After the installation,
MAKE SURE
that the unit is
supported by the
leveling legs NOT
by the cooktop.
else it could cause damage to the cooktop
voiding the warranty. Level the unit if
needed.