Owner Manual
Table Of Contents
- Introduction
- Important Safety information
- Features (Frigidaire)
- Features (Gallery/Professional)
- Installation
- Door Removal
- Door Handle Installation (some models)
- Water Supply Connection
- Ice Maker
- Controls and Settings
- Storage Features
- Normal Operating Sounds
- Filter Replacement
- Care and Cleaning
- Troubleshooting
- Limited Warranty
25
STORAGE FEATURES
Auto-Humidity Control
(some models)
Some crispers have an auto-humidity
control at the rear of each crisper under
the humidity control cover.
To remove the auto humidity control
for cleaning:
1. Reach to the back of the humidity
control cover.
2. Pull up on the cover.
3. Pull the cover toward the back of
the cabinet and remove.
4. Clean the humidity control with hot
soapy water.
5. Replace the clean humidity control
cover by reversing the steps above.
Repeat for both crispers.
NOTE
We do not recommend replacing the
auto-humidity membrane unless it
becomes damaged or ruined. If the
membrane becomes soiled, it can be
washed with soap and water. Ensure
the membrane is dry before replacing it
in the cover and back in the unit.
Remove the auto humidity cover