Use and Care Guide
Table Of Contents
- Product Record and Registration
- Important Safety Instructions
- Cooking Recommendations
- Before Setting Oven Controls
- Setting Oven Controls
- About Your Microwave Oven
- Radio or TV Interference
- About Microwave Cooking
- About Foods
- About Utensils and Coverings
- Accessories
- About Children and the Microwave
- About Food Safety
- Preparing Food for Microwave Cooking
- Before Using Microwave Oven
- Microwave Features
- Display
- Before Operating the Microwave
- Control Panel
- Figure 3: Microwave Control Pad
- 1. Lock: Use to lock the controls to prevent accidental use.
- 2. Settings / User Preferences
- 3. Presets
- 4. Melt/Soften
- 5. Auto Cook
- 6. Sensor Cook
- 7. Power level (10 power levels available)
- 8. Timer On-Off
- 9. Number Keys
- 10. START/+30Sec.
- 11. STOP/Cancel: Clears all previous settings if pressed before cooking starts. During cooking, press once to pause (and START to resume); press twice to stop and clear all entries.
- Figure 3: Microwave Control Pad
- Quick Start
- Timed Heating
- Timer
- Setting Power Level
- 1. Use the number pad to enter the time in minutes and seconds. For example, to heat for 5 minutes and 30 seconds, enter 5 3 0.
- 2. Press the Power Level pad until the desired level displays. For example, press once for high power (PL- HI). Press Power Level four times to change to 70% power (PL-70). The selected power level appears in the display.
- 3. Press START.
- Multi-Stage Cooking
- Add Cook Time (+30 Sec)
- Defrost
- Popcorn
- Potato
- Veggies
- Beverage
- Melt / Soften
- Auto Cook
- Sensor Cook
- Reheat
- Keypad Lock
- Set Clock
- Audible Signal Elimination
- 1. Press the Settings pad twice.
- 2. “VOLUME” shows in the display. “LOW”, “MED”, and “HIGH” will show in a cycle.
- 3. Press START when the desired volume is shown in the display.
- 1. Press the Settings pad 3 times. “Lb / KG” shows in the display.
- 2. Press START to change the setting. “KG” or “LB” will briefly display to show the new setting.
- Setting the Microwave
- Care and Cleaning
- Before You Call
- Warranty
15
Oven Vent Location
The oven is vented as shown below. When the oven is on,
warm air is released through the vent. This venting is
necessary for proper air circulation in the oven and good
baking results. Do not block oven vent. Never close off the
openings with aluminium foil or any other material. Steam or
moisture may appear near the oven vent; this is normal.
Types of oven racks
• Flat oven racks may be used for most cooking needs
and may be placed in most oven rack positions.
• The fully extendable glide rack makes food preparation
easier. This oven rack has glide tracks that allow the
rack to be pulled away from the oven without rubbing
the sides of the oven wall.
Removing, replacing, and arranging flat or offset
oven racks
To arrange - Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To remove - Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To replace - Place the oven rack on the rack guides on
both sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.
Figure 1: Do not block oven vent location
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks, and cooktop will become very hot which can cause
burns.
Protective Liners — Do not use aluminum foil or any other
materials to line the oven bottom, walls, racks or any part
of the oven. Only use aluminum foil as recommended in
this manual. Improper installation of these liners may
result in risk of electric shock or fire.
All oven racks should be removed before a self clean
operation. Racks left in the oven during the high heat of
the self clean function can easily discolor.
The ability of the racks to easily slide in and out along the
rack positions may also be affected.
oven vent
location
CAUTION
WARNING
IMPORTANT
Figure 2: Oven rack types
glide
rack
BEFORE SETTING OVEN CONTROLS