Use and Care Guide
Table Of Contents
- Product Record and Registration
- Important Safety Instructions
- Cooking Recommendations
- Before Setting Oven Controls
- Setting Oven Controls
- About Your Microwave Oven
- Radio or TV Interference
- About Microwave Cooking
- About Foods
- About Utensils and Coverings
- Accessories
- About Children and the Microwave
- About Food Safety
- Preparing Food for Microwave Cooking
- Before Using Microwave Oven
- Microwave Features
- Display
- Before Operating the Microwave
- Control Panel
- Figure 3: Microwave Control Pad
- 1. Lock: Use to lock the controls to prevent accidental use.
- 2. Settings / User Preferences
- 3. Presets
- 4. Melt/Soften
- 5. Auto Cook
- 6. Sensor Cook
- 7. Power level (10 power levels available)
- 8. Timer On-Off
- 9. Number Keys
- 10. START/+30Sec.
- 11. STOP/Cancel: Clears all previous settings if pressed before cooking starts. During cooking, press once to pause (and START to resume); press twice to stop and clear all entries.
- Figure 3: Microwave Control Pad
- Quick Start
- Timed Heating
- Timer
- Setting Power Level
- 1. Use the number pad to enter the time in minutes and seconds. For example, to heat for 5 minutes and 30 seconds, enter 5 3 0.
- 2. Press the Power Level pad until the desired level displays. For example, press once for high power (PL- HI). Press Power Level four times to change to 70% power (PL-70). The selected power level appears in the display.
- 3. Press START.
- Multi-Stage Cooking
- Add Cook Time (+30 Sec)
- Defrost
- Popcorn
- Potato
- Veggies
- Beverage
- Melt / Soften
- Auto Cook
- Sensor Cook
- Reheat
- Keypad Lock
- Set Clock
- Audible Signal Elimination
- 1. Press the Settings pad twice.
- 2. “VOLUME” shows in the display. “LOW”, “MED”, and “HIGH” will show in a cycle.
- 3. Press START when the desired volume is shown in the display.
- 1. Press the Settings pad 3 times. “Lb / KG” shows in the display.
- 2. Press START to change the setting. “KG” or “LB” will briefly display to show the new setting.
- Setting the Microwave
- Care and Cleaning
- Before You Call
- Warranty
24
SETTING OVEN CONTROLS
Setting Broil
Use the broil function to cook foods that require direct
exposure to radiant heat for optimum browning results.
Broiling may produce smoke. If smoke is excessive, place
food further away from the element.
The broil feature preset to 550°F. Broil may be set at any
temperature between 400°F (205°C) and 550°F (288°C).
Important: Broiler pans and inserts allow the grease to
drain away from the high heat of the broiler. Do not use the
pan without the insert. Do not cover the insert with foil – the
exposed grease could ignite.
Note: OPEN DOOR BROIL SHUTOFF: If the oven door is
left open during Broil for more than 3 minutes an alarm will
sound to notify the user to close the oven door. If the door is
not closed the oven will turn off within 30 seconds of the
open door alarm.
To set broil with the default broil oven temperature of
550°F:
1. Arrange the oven racks when cool. For optimum
browning results, preheat oven for 2 minutes before
adding food. Broil can be set with Start Time.
2. Press Broil. Broil with oven door closed.
3. Position bakeware in oven.
4. Press OK/START. To adjust the broil temperature,
press Broil again and then enter the new temperature
using the number keys. Press OK/START.
5. Broil on one side until food is browned; turn an broil
other side until done to your satisfaction.
6. When finished broiling, press OFF.
To cancel broil at any time, press OFF.
Note: If a broiler pan and insert are not supplied with this
appliance they may be purchased from frigidaire.com
Should an oven fire occur, leave the oven door closed
and turn off the oven. If the fire continues, use a fire extin-
guisher. Do not put water or flour on the fire. Flour may be
explosive and water can cause a grease fire to spread
and cause personal injury.
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior, oven racks, and
cooktop will become very hot which can cause burns.
WARNING
CAUTION
Figure 15: Broil pan with inseert(L) Rack Positions (R)
1
2
3
4
5
6