Installation guide

ManualsBrandsFrigidaire ManualsWall oven/microwave comboOfficial Frigidaire built-in oven

INSTALLATIONANDSERVICEMUSTBEPERFORMEDBYAQUALIFIEDINSTALLER.

IMPORTANT:SAVEFORLOCALELECTRICALINSPECTOR'SUSE.

READANDSAVETHESEINSTRUCTIONSFORFUTUREREFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

United States

and Canada

Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier. The

first step of your installation should be to measure your current cutout dimensions and compare them to the cutout

dimensions chart below for your model, You may find little or no cabinet work is necessary,

Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven.

These spacers center the oven in the space provided, The oven must be centered to prevent excess heat

buildup that may result in heat damage or fire,

NOTES:

1. Base must be capable of supporting 225 pounds (102 kg).

2. Allow at least 21" (53.3cm) clearance in front of oven for door

depth when it is open.

3. Dimension G (cutout depth)is

critical to the proper installation

of the built-in oven. If the

oven decorative trim does not

butt against the cabinet verify

dimension G to assure it is the

required depth,

Suggested distance from floor

is 11½" (29.2 cm).

Minimum required distance is

4 ½" (11.4 cm)

i ...........

Door Open

(see note 2)

ii !!i!!i!

40-15/16"

(104 cm)

J_ 111/2"

(29.2 cm)

_- Spacer

2" (5 cm) Wide

Spacer if Needed

Figure 1

Hole for

Cable

(right or

depending

on model)

3" (7.6 cm)

Max.

Junction Box

(right or left side)

PRODUCT DIMENSIONS

MODEL A I __ 1 _-_T'_,C_'77"7T_, ' _

27" (68.6cm) Wall Oven 27 (68.6) 42¾ (108.6) | 24/8 (62.5) 24¾ (62.9)

30" (76.2cm) Wall Oven 30 (76.2) 423/4 (108.6) / 281¼ (71.8) 243/4 (62.9)

CUTOUT DIMENSIONS AND CABINET WIDTH

27" (686cm) Wall Oven 1 247/s I 251/4 (641) l(63.2) 233/4(603)

30" (76.2cm) Wall Oven I 28½ (72.4)__ 29 (73.7) 1 233/4

(60.3)

All dimensions are stated in inches and (cm).

1411/s (104.5) 411/4 (104.8) / 271/8 (68.9) Min

411/8(104.5) 411A(104.8)1 3°1/8(765) Min

Printed in USA

P/N 807611001 (1304) Rev. A

English - pages 1-6

Espa_ol- paginas 7-12

Fran9ais - pages 3-19

Summary of content (18 pages)

PAGE 1
United States and Canada INSTALLATION ANDSERVICEMUSTBEPERFORMED BYAQUALIFIEDINSTALLER. IMPORTANT: SAVEFORLOCALELECTRICALINSPECTOR'SUSE. READAND SAVETHESEINSTRUCTIONSFOR FUTUREREFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier.
PAGE 2
Important 1. 2. 3. 4. 5. 6. 2. Electrical Notes to the Installer Read all instructions contained in these installation instructions before installing the combination oven. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer. Oven door may be removed to facilitate installation.
PAGE 3
• • • • • (If your appliance is equipped with a white neutral conductor.) This appliance is manufactured with a white neutral power supply and a frame connected copper wire.
PAGE 4
. Cabinet where local codes DO NOT permit grounding through the neutral (white) wire, the appliance frame MUST NOT be connected to the neutral wire of the 4-wire electrical system. (see figure 4): 1. Disconnect the power supply. 2. Separate the green (or bare copper) and white appliance cable wires. 3. In the junction box: Connect appliance and power supply cable wires as shown in Figure 4. Do not lift the oven by the door handle. • • White Wire 2. Wire 3. 4. e Junction Box ......... U.L.-I i .
PAGE 5
6. Install the Anti-tip Mounting Screws The wall oven can tip when the door is open. The anti-tip mounting screws supplied with the wall oven must be installed to prevent tipping of the wall oven and injury to persons. A. The mounting holes in the side trims may be used as a template to locate the appliance mounting screw holes (see figure 6). B. Use the two screws supplied to fix the appliance to the cabinet, 7.
PAGE 6
5. Leveling 1. 2. 3. the Wall Oven 7. Checking Install an oven rack in the center of the upper oven (see Figure 8). Place a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level if necessary. Repeat in the lower oven if you have a double cavity wall oven. If the level indicates that the rack is not level, use wood shims to reach a Operation Your model is equipped with an Electronic Oven Control.
PAGE 7
Estados Unidos y Canada LA INSTALACION Y EL SERVICIO DEBEN SER REALIZADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: CONSERVE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEAY CONSERVE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almacene ni utitice gasolina ni otros liquidos o vapores inflamables cerca de este o de cualquier otro etectrodomestico.
PAGE 8
Notas importantes 1. 2. 3. 4. 5. 6. para el instalador Antes de instalar la combinaci6n de homo, tea todas las instrucciones de instalaci6n. Antes de conectar et suministro de electricidad al homo de pared, retire todo et material de empaque de los compartimientos det homo. Aseg0rese de que se cumplan todas las normas y los c6digos relevantes. Aseg0rese de dejar estas instrucciones en poder det usuario. Se puede quitar la puerta det homo para facititar la instalaci6n.
PAGE 9
Riesgo dechoque etectrico • • • • • Se requiere conexi6n a tierra en este electrodomestico. No conecte al suministro etectrico hasta que et etectrodomestico este debidamente puesto a tierra. Desconecte et suministro etectrico a la caja de empalme antes de hacer la conexi6n etectrica. Este etectrodomestico debe conectarse a un sistema etectrico metalico permanente puesto a tierra, o un conector a tierra debe conectarse at terminal de conexi6n a tierra o cable en el electrodomestico.
PAGE 10
conexi6n atierraa travesdetcableneutro(blanco), etmarco 4. Instalaci6n en el mueble detetectrodomestico NODEBEconectarse alcableneutro detsistema etectrico de4 cables. (vealafigura4): 1. Desconecte etetectrodomestico detsuministro etectrico. No levante et homo por la manija de la puerta. 2. Separeloscablesverde(odecobredescubierto) y btanco detetectrodomestico. 3.Enlacajadeempalme: Conecte etetectrodomestico yloscablesdetsuministro etectrico comosemuestra enlafigura4.
PAGE 11
6. Instale lostornittos demontaje antivuetco 7. Instale lamoldura inferior Elhomodepared puede volcarse cuando la IMPORTANTE: La moldura inferior debe estar instalada puerta estaabierta. Sedeben instalar lostomitlos demontaje para que et homo funcione correctamente. NO ponga el antivuelco proporcionados conethomo depared paraevitar homo en funcionamiento sin que este instalada la moldura etvuetco dethomo deparedy tesiones alaspersonas, det fondo det homo, A.
PAGE 12
5. Nivelaci6n 1. 2. 3. del horno de pared Instale una parritta en et centro det homo superior (vea la figura 8). Coloque un nivet en ta parritla. Realice 2 tecturas con et nivet colocado en forma diagonal en una direcci6n y luego la otra. Use cutlas de madera debajo det homo de pared para nivetarlo si es necesario. Repita en et homo inferior si tiene un homo de pared de cavidad dobte.
PAGE 13
Fttats-Unis et Canada L'INSTALLATtON ETL'ENTRETtEN DOtVENT ETRE REALISES PARUNINSTALLATEUR QUALtFIE. IMPORTANT : CONSERVEZ CESINSTRUCTIONS ENPRFtVISION D'UNUSAGE Ft:VENTUEL PAR L'INSPECTEUR EN Ft:LECTRICITF 1:DE VOTRE LOCALITF 1:. VEUILLEZ LIRE ET CONSERVER CES INSTRUCTIONS POUR VOUS Y REPORTER ULTFt:RIEUREMENT. POUR VOTRE S¢:CURIT¢: : Vous ne devez ni entreposer, ni utiliser d'essence ou d'autres vapeurs ou liquides inflammables a proximite de cet appareil ou de tout autre appareil electrom6nager.
PAGE 14
Remarques 1. 2. importantes pour I'installateur Lisez toutes les instructions contenues dans ce guide avant de proceder a I'installation du four combin& Retirez tout le materiel d'emballage des compartiments du four avant de mettre le four encastre sous tension. 3. 4. Respectez tous les codes et tousles reglements. Assurez-vous de laisser ces instructions a I'utilisateur. 5. Vous pouvez retirer la porte du four pour en faciliter I'installation.
PAGE 15
Risquededecharge electrique • • • • • Une mise a la terre electrique est requise sur cet appareil. Ne vous raccordez pas a I'alimentation electrique avant que I'appareil ne soit mis & la terre de fagon permanente. Debranchez I'alimentation & la bofte de jonction avant d'effectuer le branchement electrique.
PAGE 16
unvehiculerecreatif oudanslesregionsoQlescodes IocauxNEPERMETTENT PASla misea laterreparle fil neutre(blanc),lecadredeI'appareil NEDOlTPAS 6trebrancheaufil neutredusystemeelectrique a 4 ills (reportez-vous a lafigure4) : 1. CoupezI'alimentation electrique. 2. Separezlefil vert(oufil nuencuivre)dufil blanc deI'appareil. 3.Danslaboftedejonction: Branchez lesillsde I'appareil etdeI'alimentation electrique commeillustrea lafigure4. 4.
PAGE 17
6. Installez les vis de montage anti-renversement. Le four encastre peut basculer vers I'avant Iorsque la porte est ouverte. Les vis de montage anti-renversement fournies avec le four encastre doivent etre installees pour eviter le renversement du four encastre et les blessures. A. Les trous de montage dans les garnitures laterales peuvent etre utilises comme gabarit pour Iocaliser les trous des vis de montage de I'appareil (figure 6). B. Utilisez les deux vis fournies pour fixer I'appareil I'armoire. 7.
PAGE 18
5. Mise a niveau 1. 2. 3. du four encastre Installez la grille au centre du four superieur (figure 8). Placez un niveau sur la grille. Prenez deux lectures en plagant le niveau diagonalement dans un sens, puis dans I'autre sens. Utilisez des cales en bois sous le four encastre pour le mettre a niveau au besoin. Refaites ces etapes pour le four inferieur si vous avez un modele de four encastre double.