Owner's Guide
Table Of Contents
- Product Record and Registration
- Important Safety Instructions
- Cooking Recommendations
- Before Setting Oven Controls
- Setting Oven Controls
- About Your Microwave Oven
- Radio or TV Interference
- About Microwave Cooking
- About Foods
- About Utensils and Coverings
- Accessories
- About Children and the Microwave
- About Food Safety
- Preparing Food for Microwave Cooking
- Before Using Microwave Oven
- Microwave Features
- Display
- Before Operating the Microwave
- Control Panel
- Figure 3: Microwave Control Pad
- 1. Lock: Use to lock the controls to prevent accidental use.
- 2. Settings / User Preferences
- 3. Presets
- 4. Melt/Soften
- 5. Auto Cook
- 6. Sensor Cook
- 7. Power level (10 power levels available)
- 8. Timer On-Off
- 9. Number Keys
- 10. START/+30Sec.
- 11. STOP/Cancel: Clears all previous settings if pressed before cooking starts. During cooking, press once to pause (and START to resume); press twice to stop and clear all entries.
- Figure 3: Microwave Control Pad
- Quick Start
- Timed Heating
- Timer
- Setting Power Level
- 1. Use the number pad to enter the time in minutes and seconds. For example, to heat for 5 minutes and 30 seconds, enter 5 3 0.
- 2. Press the Power Level pad until the desired level displays. For example, press once for high power (PL- HI). Press Power Level four times to change to 70% power (PL-70). The selected power level appears in the display.
- 3. Press START.
- Multi-Stage Cooking
- Add Cook Time (+30 Sec)
- Defrost
- Popcorn
- Potato
- Veggies
- Beverage
- Melt / Soften
- Auto Cook
- Sensor Cook
- Reheat
- Keypad Lock
- Set Clock
- Audible Signal Elimination
- 1. Press the Settings pad twice.
- 2. “VOLUME” shows in the display. “LOW”, “MED”, and “HIGH” will show in a cycle.
- 3. Press START when the desired volume is shown in the display.
- 1. Press the Settings pad 3 times. “Lb / KG” shows in the display.
- 2. Press START to change the setting. “KG” or “LB” will briefly display to show the new setting.
- Setting the Microwave
- Care and Cleaning
- Before You Call
- Warranty
33
SETTING OVEN CONTROLS
Restoring Factory Default Settings
Your appliance was set with predetermined (default) oven
control settings. Over time, users may have made changes
to these settings. The following options may have been
modified since the appliance was new:
• 12 or 24 hr display mode
• All Meat Probe settings
• Continuous bake or 12 hour energy savings mode
• Silent or audible control
• Oven temperature display (Fahrenheit or Celsius)
• Oven temperature adjustments (UPO)
To restore oven control to factory default settings:
1. Press and hold 7 on numeric keypad until acceptance tone
sounds (about 6 seconds).
2. Press OK/START. The control has been reset with the default
settings.
Adjusting Oven Temperatures
Your appliance has been factory calibrated and tested to
ensure accurate baking temperatures. For the first few
uses, follow your recipe times and temperature recommen
-
dations carefully. If you think the oven is cooking too hot or
too cool for your recipe times, you may adjust the control so
the oven cooks hotter or cooler than the oven temperature
displayed.
Important: Do not use oven thermometers such as those
found in grocery stores to check the temperature settings
inside your oven. These oven thermometers may vary as
much as 20 to 40°F degrees from actual temperatures.
The oven temperature may be increased as much as +35°F
(+19°C) or decreased -35°F (-19°C) from the factory cali
-
brated settings.
To increase or decrease the oven temperature by 20°F:
1. Press and hold Bake until the control produces an
audible tone (about 6 seconds). The factory offset
temperature of 0
(zero) should appear in the display.
2. Enter 2 0 using numeric keypad.
3. To offset the oven by -20°F, press self clean to toggle
between + and -.
4. Press OK/START to accept change.
Important note:
• Oven temperature adjustments will not change the
Broil, Self Clean, or Keep Warm temperatures.
• The oven temperature adjustment may be made if your
oven control is set to display temperatures in °C
(Celsius). Minimum and maximum settings for Celsius
range from plus (+)19°C to minus (-) 19°C.
All of the above user settings will be restored to the
factory default settings.
CAUTION