Important Safety Instructions..............................2-3 Air Conditioner Features.....................................8 Product Registration...............................................4 Operating Instruction......................................8-17 Normal Sounds.......................................................4 Care and Cleaning.............................................18 Unit Description......................................................5 Before You Call........................
Important Safety Instructions NOTE: NOTE: WARNING WARNING WARNING WARNING SAFETY PRECAUTIONS
Important Safety Instructions SAFETY PRECAUTIONS Provide ventilation per installation instructions. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively. NOTE: fails manufacturer. manufacturer.
Product Registration & Normal Sounds Product Registration Record Your Model and Serial Numbers 3FDPSE JO UIF TQBDF QSPWJEFE CFMPX UIF NPEF BOE TFSJBM OVNCFST 0O BMM NPEFMT UIF TFSJBM QMBUF JT MPDBUFE PO UIF TJEF PG UIF DBCJOFU Model No. Serial No.
Unit Description & Accessories Included Unit Description Air Outlet Grill Control Panel Carrying Handle Signal Receiver Air Exhaust Remote Control Continuous Drain Outlet Air Intake Power Cord Heat Pump Drain Outlet (for heat pump model) Bottom Drain Outlet Castor Accessories Included PARTS: PARTS NAME: QUANTITY: Window Kit Connector A Exhaust hose connector B Window Kit Exhaust Hose ( Screws ( + ) ) Safety Lock Bolts Foam seal A Foam seal B Remote Control Battery Drain hose Drain hose a
Installation Instructions Installation Instructions EXHAUSTING HOT AIR In the Cool Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position unit on a flat floor and is within the vicinity of a single circuit outlet power source. Make sure there’s a minimum of 31.5" clearance in the front/back of the unit, and a minimum of 19.7" clearance in the left/right sides of the unit. 31.5" 19.7" 1. Extend both side of the exhaust hose(Fig.1) 2.
Installation Instructions Installation Instructions(continued) Installation in a double-hung sash window 1.Cut the foam seals A(adhesive type) to the proper lengths and attach them to the window and stool.(Fig.6) 2.Open the window sash and place the window slider kit on the window stool (Fig.7). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the width of window. Screw down the two screws on the window slider kit. See Fig.7.
Air Conditioner Features & Operating Instructions Control Panel %JTQMBZ 5FNQFSBUVSF 5JNFS °C °F 4XJOH 5JNFS 4MFFQ .
Operating Instructions Dry mode Press the “mode” button until the Dry mode indicator lights. In this mode, the “ ” or “ ” button is disabled and the screen displays the room temperature. The unit will continuously drain moisture from the room. Note: In this mode, the fan speed will be set as “low” automatically, which cannot be changed. In this mode, condensate drainage are required, refer to the "Drainage Instructions" on Page 16-17 for more instructions to drain the excess condensate.
Operating Instructions AUTO mode Press the “mode” button until the AUTO mode indicator lights. Press the “ ” or “ ” button to choose the temperature you want. The screen will display the setting temperature. In this mode, the unit will automatically select cooling, heating(not applicable for cooling only models), or fan only operation depending on what temperature you have selected and the room temperature.
Operating Instructions Sleep mode When the unit is in Cool, Heat or Auto mode, you can press the “sleep” button to make the unit run in Sleep mode. In this mode, the fan speed will be set as “auto” automatically, which cannot be changed. In Cool/Heat mode the selected temperature will increase/decrease by 2 °F 30 minutes after the mode is selected. The temperature will then increase/decrease by another 2 °F after an additional 30 minutes.
Operating Instructions Remote Control Cool Only models 3FNPUF $POUSPM TDSFFO 5FNQ 5JNFS TFUUJOH CVUUPO .
Operating Instructions How to Use the Remote Control TURNING THE UNIT ON Plug in the unit, then press the “on·off” button (when turned on, the unit will operate as the last setting before shutdown. To switch the unit off, press “on·off” button again, then remove the plug. Do NOT switch the unit off by removing the plug. Always switch the unit off by pressing the “on·off” button and wait for few minutes before removing the plug.
Operating Instructions Heat mode(For Heat & Cool models only) Press the “mode” button until the left side of LCD screen displays “heat”. Press the “ ” and “ ” button to choose the temperature you want. Press the “ fan speed” button to choose the fan speed “auto”, “high”, “mid”, and “low”. Note: In this mode, condensate drainage are required, refer to the "Drainage Instructions" on Page 16-17 for more instructions to drain the excess condensate.
Operating Instructions function Press the “ ” and “ ”button the same time for more than 3 seconds to switch between degree Fahrenheit and degrees Celsius. Note: Under Dry/Fan mode, you can not select °F/°C. Timer mode How to delay startup Plug in the unit, so the unit turns to standby. Press the “timer” button, when the unit is off. The screen will display “timer” and “h”, and the “on” will flashing. Tap or hold the UP arrow " " or the DOWN arrow " " to change delay start timer at 0.
Operating Instructions Drainage Instructions Continuous Drainage During the Dry mode, you will need a garden hose (sold separately) to drain the condensate from the unit. Follow the steps below: Unscrew the drain cap of continuous drain outlet(Fig.20). Connect one end of the garden hose (sold separately) to the drain outlet then lead the other end into a drain that is lower than the unit(Fig.21).
Operating Instructions Drainage Instructions NOTE: There is a 1/4” hole on the window kit for leading the drainage hose outside during the heating mode. Do not drain condensate outside when outside temperature is below 32°F (0°C). Figure 24 Window slider kit 1/4" hole Emptying the condensate residue inside the unit during winter storage. Put a drip tray (not supplied) under the continuous drain outlet, then unscrew the drain cap to allow the condensate to flow into the drip tray.
Care and Cleaning Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. CLEANING THE UNIT The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. Never use harsh cleaners, wax or polish on the cabinet front. Be sure to wring excess water from the cloth before wiping around the controls.
Before You Call 2009 Electrolux Home Products, Inc. All rights reserved.
Major Appliance Limited Warranty Your appliance is covered by a limited one-year warranty for functional repairs only. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
