Warranty

Filter reset
This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation.
The filter indicator will illuminate after 250 hours of fan operation. Press the “filter reset” button, to reset after cleaning
the filter.
Operating Instructions
°C
°F
Sleep mode
When the unit is in Cool, Heat or Auto mode, you can press the “sleep” button to make the unit run in Sleep mode.
In this mode, the fan speed will be set as “auto” automatically, which cannot be changed.
In Cool/Heat mode the selected temperature will increase/decrease by 2 °F 30 minutes after the mode is selected.
The temperature will then increase/decrease by another 2 °F after an additional 30 minutes. This new temperature
will be maintained for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" mode
and the unit will continue to operate as originally programmed.
The "Sleep" mode program can be cancelled at any time during operation by pressing the "Sleep", “mode”, “fan speed”
or “on·off” button.
Note: In Fan or Dry mode, Sleep mode cannot be set.
During Sleep mode the brightness of the indicators will reduce by half.
°C
°F
Louver Swing Function
Press the “swing” button to enable louver swing function, the swing indicator will illuminate and the louver on the top
panel will swing up and down. Press this button again to disable the louver swing function.
°C
°F
Press the “ ” and “ ”button the same time for more than 3 seconds to switch between degree Fahrenheit and
degrees Celsius.
Note: Under Dry/Fan mode, you can not select °F/°C.
function