User Manual

11OPERATING INSTRUCTIONS
Note: In this mode, the unit will select Auto
fan speed automatically, and the selected
temperature will increase by 2 °F 30 minutes
after the mode is selected. The temperature
will then increase by another 2 °F after an
additional 30 minutes. This new temperature
will be maintained for 7 hours before it
returns to the originally selected
temperature. This ends the "Sleep" mode
and the unit will continue to operate as
originally programmed. The "Sleep" mode
program can be cancelled at any time
during operation by again pressing the
"Sleep".
Note: This feature is a reminder to clean the
Air Filter (See Care and Cleaning) for more
efficient operation. The LED (light) will
illuminate after 250 hours of operation. To
reset after cleaning the filter, press the
"Filter Reset" button and the light will go off.
SLEEP FEATURE:
CHECK FILTER FEATURE, YOU WILL SEE:
YOU WILL SEE:
PRESS SLEEP
BUTTON
DO THIS:
TIMER: DELAY STOP/START FEATURE:
PRESS UP/DOWN
BUTTONS
THEN DO THIS:
PRESS TIMER
BUTTON
FIRST DO THIS:
YOU WILL SEE HOW MUCH TIME IS
CHOSEN:
Note: For Delay Stop, the unit must be in the
On position. Note: For Delay Start, the unit
must be in the Off position. First, Press
TIMER button, then adjust timer setting, tap
or hold the UP arrow ( ) or the DOWN
arrow ( ) to change delay timer at 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start (8,
7.5, 7, etc.). The Delay Start Operation
automatically selects cooling with maximum
Fan speed (if Cool, Energy Saver, or Fan
Only was the last mode selected) . The
temperature maintained will be the same as
previously set. To change the set
temperature, press "COOL" then Up or
Down arrows until the desired temperature
is indicated on the display. After 5 seconds,
the control will automatically change the
display back to the hours remaining until the
unit will start/stop. Pressing the unit On/Off
button at any time will cancel the Delay
Start/Stop function. The Delay Start/Stop
Feature will work until the unit either starts
or stops. Once that happens the above steps
have to be repeated again.