Use & care guide Guia de uso y cuidado Guide d’utilisation et d’entretien 30” and 36” Range Hood FHWC3060LSA + FHWC3660LSA 00-Elux FHWC3060LSA-Range hood-Book-01.
Finding information Table of contents Please read and save this guide ....................................... 02 Keep a record for quick reference .................................... 02 Important safety instructions.......................................02-04 NOTE Registering your product with Frigidaire enhances our ability to serve you. You can register online at www.frigidaire.com or by dropping your Product Registration Card in the mail. Electrical requirements.....................................
e e l Important safety instructions Important safety instructions IMPORTANT Indicates installation, operation, or maintenance information which is important but not hazard-related. Child safety Packing materials: • Packing cartons covered with rugs, bedspreads, plastic sheets, or stretch wrap may become airtight chambers and can quickly cause suffocation. • Remove the protective film covering the appliance before putting it into operation.
Important safety instructions Important safety instructions WARNING To reduce the risk of fire, use only metal duct work. Install this hood in accordance with all requirements specified. WARNING To reduce the risk of fire or electric shock, do not use this hood with any external solid state speed control device. WARNING To reduce the risk of a cooker top grease fire: • Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite.
Installing the hood • Do not have a fuse in the neutral or ground circuit. 3 Upper and lower chimney 1 + 1 4 Upper bracket 1 5 Lower bracket 1 6 Collar 1 7 Recirculation kit (optional accessories) -FHWRKT60LS 1 8 Bulb 20W, 120V~, GU10 (pre-assembled) 2 9 Bolt, rubber washer, washer 4 sets 10 Long screw (4mm x 32mm) 8 11 Wall plug 8 12 Short screw (4mm x 12mm) 4 13 Allen key 1 14 Wood screw (4mm x 50mm) Short screw (3.5mmx8mm) 4 15 Short screw (3.
Installing the hood Installing the hood • • IMPORTANT • We recommend that two people carry out the installation. Pay attention to the procedure described in the assembly instructions. • Preparation • • • • Determine the exact location of the range hood. Plan the route for venting exhaust to the outdoors ). Plan the power connection prior to installation so that electrical wiring will not be visible afterwards.
Installing the hood • Flexible metal round ducts should only be used when no other duct fitting exists. Limit use to short lengths and do not crush when making corners. 7 fig. Examples of possible ducting or air recirculation fig. Roof pitch with flashing and cap Pipe Collar Sidewall cap Pipe Collar Recirculator Pipe Collar IMPORTANT Framing must be capable of supporting 100 lbs. Installing range hood to the wall (Exhaust operation) IMPORTANT This range hood is very heavy.
Installing the hood • fig. Ceiling 0.9” Long screws 9.8” 9.3” • 9.13” Wood screws fig. 9.8” 7.5” fig. 10” Dimension A (see table) Wall Insert 2 screws (10 or 14) in the top location, but do not fully insert the screws (fig. ). Mount the range hood (1) to the wall and tighten the screws. Insert and tighten the 2 remaining screws on the bottom location of the range hood (fig. / ). Attach the collar (6) to the range hood (1). Secure with 2 short screws (12) (fig. ). 0.08” fig. fig. 0.
Installing the hood t e . e fig. fig. fig. fig. 9 L (live) = Black N (neutral) = White (ground) = Green L e N • Mount the junction box onto the range hood using 2 short screws (15) (fig. ). Electrical connections fig. DANGER Danger of electric shock! All fittings must be installed by a competent person in accordance with current wiring regulations and local building regulations. If in doubt, consult a qualified electrician.
Installing the hood CAUTION Danger of injury. The chimney skirts may have some sharp edges. Installing range hood to the wall in recirculation mode • • Exhaust operation • • • • • • • During exhaust operation, the range hood removes air from a room. If other fire sources that require the surrounding air for combustion are being operated in the same room, (e.g. gas, oil or coal heaters), the oxygen they require is taken away.
e e t n e Regularly Button Function o Press button o to switch the appliance off (pilot lamp is lit when appliance is switched on). • Press button • for low speed. •• Press button •• for medium speed. ••• Press button ••• for high speed. Press button to turn on lights. Press again to switch lights off. For best performance e s e Press one of the speed ( • / • • / • • • ) buttons to turn the appliance on.
Troubleshooting fig. fig. Suction performance is not good. fig. Readjust the distance (page 7, fig. and table below) Metallic antigrease filter is dirty. Clean filters (see Cleaning and maintenance). 120V~, 60Hz 520W 2x 20W, 120V~ (type: GU10) 18AWG (Amer. Wire Gauge) 300V~, 105˚C Excessive vibration. Both light and fan do not work. 6 7 8 Solution The appliance is not fixed properly on the brackets. Take down the appliance and check it is properly fixed. 9 Switch off the appliance.
t . . Warranty information 13 Warranty information DISCLAIMER OF IMPLIED WARRANTIES; Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
