GB Finding information Table of contents Please read and save this guide Keep a record for quick reference... important safety instruction Electrical requirements Intended use Parts supplied... installing the hood. Operation... Cleaning and maintenance... Technical data... Troubleshooting Environmental protection Warranty information Please read and save this guide Thank you for choosing Frigidaire, the new premium brand in home appliances.
Important safety instructions 3 important safety instructions A WARNING — IMPORTANT To reduce the risk of fire, electric shuck, or Indicates installation, operation, of maintenance information which is important but not hazard-relaid, ° w inquiry to persons, observe the following: FOR RESIDENTIAL USE ONLY. Use his appliance only in the manner intended by the manufacturer. Bf you have questions, contact the manufacturer.
GB important safety instructions Important safety instructions IN waning Ta reduce the risk of fire, Lge only metal duct work. install this hood In accordance with all requirements specified, JI warning Toreador the risk of fire or electric shock. do not use this hood with any external solid state speed control device. AN WARNING To reduce the vise of a cooker top grease fire: Never leave surface snits unattended at high settings. Rollovers cause smoking and greasy spillovers that may ignite.
o3 IMPORTANT Soave distillation instillation dor dialectical appreciators ise. he noe hood must be connector wile copier wire only, he range hood should be connected distally 10 the fused discovered (or Riel breaker) box Hour mel selection) conj. Wire sizes must conform fo the requirements of the National Electrical Code PANSY 70 — latest edition”, or CSA Standards Canadian Electrical Code Part 1 and G22.2 latest edition™ and all local codes and ordinances. A UL. or C.8.A.
GB Installing the hood Installing the hood a IMPORTANT We recommend that twe peep cray outs installation Patiently to he organized adsorbed Ib the assembly distinctions ff Preparation » » Determine the exact location of the range hood. Plan the route for venting exhaust to the outdoors (fig. Plan the power connection prior to installation so that electrical wiring will not be visible afterwards. House wiring location: The junction box is located on the top right side of the hood.
Examples of possible ducting or air re circulation fig. Roof pitch with hing and cap Sidewall cap Directorate 1 Pipe Pipe Pipe Cottar JE © Collier Go liar Installing range hood to the wall {Exhaust operation} os IMPORTANT This range bond ls very heady Adequateness And support st be provided In all toes of Hamilton install framing for hood support e if drywall is present, mark the screw hole locations. « Cut away enough drywall to expose 2 vertical studs at the holes location indicated by the template.
Installing the hood GB Wood screws 16.38" -FHWEI0S5L | dimension 23.86" -FHWC36S5L. Wall ‘ (see table) Desired range hood distance above a 36” high cook top Ceiling height & Feet 9 Feet 10 Feet mere ie wane | 5256 337 a 355/18 | 35-5016” 35” “with 10" extension chimney kit FW10EXS5LS {14) (not supplied). Please call Frigidaire at 1.800.944.8044 to order this kit. 2 “Dimension A” in the chart represents the height from cook top to where the bottom screw mounting holes would be located.
Electrical connections /N DANGER Banger of techie shock All Bindings most be installed by a competent person in accordance with current wiring regulations and local building regulations. If in doubt, consult a nullified electrician nd IMPORTANT Always switch off the lecherously supply at the lams during installation cleaning ad incandescence. We second that the fuse is withholding or ti cult breaker switched off at the distribution board wile Soi 8 1 piousness.
Installing the hood . GB JIN CANTON Danger of injury, The chimney skirts may have some sharp edges. exhaust operation During exhaust operation, the range hood removes alr from a room, If other fire sources that require the surrounding air for combustion are being operated in the same room, {e.g. gas, oil or coal heaters), the oxygen they require is taken away. Thus flames could be suffocated and gas could leak out or the fumes could be drawn back into the room.
Operation / Cleaning and maintenance Take out the grease filters and fit charcoal filters to twa lateral sides of the motor blower. Assemble back the grease filters (fig. @3). Operation Press one of the speed buttons to turn the appliance on. Button | Function © Press button to switch the appliance off {pilot lamp is lit when appliance is switched on). Press bunion « for low speed. we Press button «= for medium speed. ese Press button see for high speed. PY Press button 28% to tum on fights.
Troubleshooting GB =i IMPORTANT Clean the filter Avery month fo prevent nek of Hee Maintenance + User servicing Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Light bulb replacement + Switch the appliance off and disconnect the power supply. + in order to replace the light bulb {7), the metallic anti~grease filter should be detached first. + Pull the spring lock downward (fig.
Warranty information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolyte will pay all costs for repairing or replacing any parts of this appliance that prove 10 be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.