User manual

1. Install the anti-tilt protection 317 - 322
mm down from the top surface of the
appliance and 80 - 85 mm from the side
of the appliance into the circular hole on
a bracket. Screw it into the solid
material or use applicable reinforcement
(wall).
80-85
mm
317-322
mm
2. You can find the hole on the left side at
the back of the appliance. Lift the front
of the appliance and put it in the middle
of the space between the cupboards. If
the space between the bench
cupboards is larger than the width of the
appliance, you must adjust the side
measurement to centre the appliance.
If you changed the dimensions of the
cooker, you must align the non-tip
device correctly.
CAUTION!
If the space between the bench
cupboards is larger than the width of
the appliance, you must adjust the
side measurement to the centre of the
appliance.
Electrical installation
WARNING!
The manufacturer is not responsible if
you do not follow the safety
precautions from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
9
INSTALLATION