Complete Owner's Guide

17
Unpacking instructions
1. If foam tub block has been removed,
reinsert it now and tape the lid securely.
2. Carefully cut the front and back
corners of the left side of the remaining
cardboard.
3. With help from a second person,
carefully tip the laundry center slightly
to the left as shown in the picture below.
Remove the foam shipping support from
the base of the unit. Save packaging
foam for future use.
4. Carefully lower the laundry center to an
upright position and remove the tape
holding the lid shut. Remove the foam
tub block, all foam inserts, and other
tub contents.
5. From the back of the washer, remove the
wire shipping clips securing the drain hose.
6. DO NOT remove the PLASTIC CLIPS
which secure the drain hose to the right
side of the washer back sheet. It helps
form a standpipe to prevent water
siphoning.
2
1
7. Carefully move the laundry center to
within four (4) feet of the final location
for the start of the installation.
Plastic
Clips
Wire
Clip
Front
IMPORTANT
To prevent vibration, possible machine
damage and maximize performance,
the following steps must be completed.

NOTE
If the laundry center is to be
transported at a later date, the tub
blocking pad, foam base and tub
support should be retained.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the appliance.
INSTALLATION