Complete Owner's Guide

9
PRE-INSTALLATION REQUIREMENTS
Shipping hardware
 Foam shipping restraint (inside
wash tub) removed and stored
 Foam shipping support (underneath
appliance) removed and stored
Leveling
 Laundry center is level, side-to-side
and front-to-back
 Cabinet is setting solid on all corners
Water supply
 Use only new hoses and verify
rubber sealing washers are installed
 HOT supply is connected to HOT
inlet and COLD supply is connected
to COLD inlet
 HOT and COLD water supply turned on
 No leaks present at water supply
connections or appliance inlet
connections -recheck in 24 hours
Drain
 Stand pipe or wall drain height min. 33”
 Drain hose secured in place with
cable tie (shipped in drum)
Exhaust venting
 Free-flowing, clear of lint buildup
 4 inch (102 mm) rigid or semi-rigid
ducting of minimal length and turns
 NO foil or plastic venting material
 Approved vent hood exhausted to
outdoors
Installation Checklist

Gas supply (Gas Dryer)
 Manual shuto valve present in supply
 All connections sealed with
approved sealer and wrench tight
 Conversion kit for LP system
 Gas supply turned on
 No leaks present at all connections -
check with soapy water, NEVER
check with flame
240V electric supply
(electric dryer)
 Approved NEMA 10-30R or 14-30R
service cord with all screws tight on
terminal block
 Approved strain relief installed
 Terminal access cover installed
before initial operation
Electrical power
 House power turned on
 Laundry Center plugged in
Final checks
 Installation Instructions and Use &
Care Guide read thoroughly
 Water enters drum when cycle
starts with lid lowered and dryer
door latches and drum tumbles
when cycle starts
 Registration card sent in
Tool requirements
Tools and materials needed for installation:
• Adjustable pliers
• Phillips, straight, & square bit
screwdrivers
• Adjustable wrench
• Pipe wrench for gas supply (gas dryer)
• LP-resistant thread tape (for natural
gas or LP supply, gas dryer)
• Carpenter’s level
• External vent hood
• 4-inch (102 mm), rigid metal or semi-
rigid metal exhaust duct work
• 3-wire or 4-wire 240 volt cord kit
(electric dryer)
• 4 in. (102 mm) clamp
• Gas line shuto valve (gas dryer)
• 1/2 NPT union flare adapters (x2) and
flexible gas supply line (gas dryer)
• Metal foil tape (not duct tape)
• Inlet hoses (x2)

NOTE
Hoses are not included with washer
purchase.