User manual

WARNING!
Put the mains plug into the mains
socket only if all parts are back into
their initial position. There is a risk
of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions on
the minimum position.
6. Remove the knob for the oven functions
again.
7. Screw on slowly the bypass screw till
the flame becomes minimum and
stable.
8. Put the knob for the oven functions
back.
9. Set the maximum gas flow position on
the knob for the oven functions and let
the oven heat for at least 10 minutes.
10. Quickly turn the knob for the oven
functions from maximum to the
minimum gas flow position.
Control the flame. Make sure the flame
does not go out when you turn the knob to
the minimum gas flow position. There must
be a small regular flame on the oven burner
crown. If the flame goes out adjust the oven
burner again.
Levelling
CAUTION!
Remove all the accessories from the
oven.
1. Open the lid of the appliance and
disassemble it.
2. Disassemble the pan supports and all
the burner assemblies.
3. Put the appliance on the sidewall on a
clean and smooth surface. Place each
foot into a separate hole, in the plinth,
and rotate it clockwise.
B
4. If the floor is not equally flat, use the
adjustable feet on the bottom of the
appliance to set a stable position for the
appliance.
33
INSTALLATION