User manual

• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp edges
or corners,
• it's conditions can be easily checked.
When checking the flexible pipe make sure:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length,
• the material is not hardened, but shows
its correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
The gas supply ramp is on the rear side of
the control panel.
Levelling
CAUTION!
Remove all the accessories from the
oven.
1. Open the lid of the appliance and
disassemble it.
2. Disassemble the pan supports and all
the burner assemblies.
3. Put the appliance on the sidewall on a
clean and smooth surface. Place each
foot into a separate hole, in the plinth,
and rotate it clockwise.
B
4. If the floor is not equally flat, use the
adjustable feet on the bottom of the
appliance to set a stable position for the
appliance.
30
INSTALLATION