User manual

13
INSTRUCTIONS FOR THE USER
To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in
the hole (F) of the hinge (g. 10).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order, paying
attention to the correct position of sectors.
Ud
Bd
S
G
Fig. 8
Ud
Bd
S
G
Fig. 9

Fig. 9A
Ud
Bd
S
G
Fig. 10
Replacing the oven lamp (g.11)
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock.
In the event one or both oven lamps need replacing, the
new lamps must comply with the following requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant to
high temperature (300°C).
Turn glass protection cap (C) counterclockwise and
change the lamp. Re-t the cap, screwing it back in a
clockwise direction.


Fig. 11
Oven seal
The oven seal guarantees the correct functioning of the
oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
Self-cleaning panels
Oven walls are protected by panels coated with a grease-
proof, microporous enamel that absorbs and eliminates
splattering during baking.
If there is a lot of liquid or grease, dry immediately with
a damp sponge and heat the oven for 2 hours on the
maximum thermostat position. Wait for the oven to cool
down and then go over it again with a damp sponge. If
you are unable to remove all the substances, repeat the
above procedure.
It is, however, advisable to periodically remove the panels
and wash them with warm soapy water and dry them
with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the previous
paragraph.
• Remove both side panels (PL) (g.12).
• Remove back panel by unscrewing respective
locking screws (V) (g. 12A).