User manual

22
INSTALLATION
Maintenance
Prior to any maintenance work or changing
parts, disconnect the appliance from the gas and
electricity power sources.
Replacing the taps
Proceed in the following way when replacing a tap:
• Remove pan supports, burner heads.
• Unscrew the burner xing screws (Vc) (g. 22).
(four for ultrarapid burner and two for the other
burners)
• Pull out the knobs.
• Unscrew the three xing screws (Vf) (g. 22) which
lock the front panel to the front frame then slip out
from the upper xing brackets.
• Unscrew the six xing screws (Vp) (g. 22) which
lock the side proles and remove it.
• Unscrew the two xing screws (Vd) (g. 22) which
lock the hob at the back and remove it.
• Unscrew the nuts (D) of the gas aluminium pipes
and pull out the thermocouple quick connectors (F)
(g. 24).
• Unscrew the screws (Vt) (g. 23) which lock the
crosspieces.
• Unscrew the screws (Vb) (g. 23) which unite the
the bridles of the taps to the front frame.
• Make to slip the ramp toward the back part and
unscrew the screws (Vb) (g. 24) in order to free
the taps.
• Change seal each time a tap is replaced. This will
ensure perfect retention between the tap or a
thermostat and part.
• Reassemble all the parts following the same
procedure but in the reverse order.



Fig. 23



Fig. 24
Changing the exible gas hose
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing it
on the date you will nd printed on it.




Fig. 22