User manual

23
INSTALLATION
Replacing the electrical components
• The rear protection will have to be removed in
order to change the electrical heating elements,
spit motor, terminal board and power cable.
• If you have to change the power cable
(see the cross section on table in the table
in the “TECHNICAL FEATURES” section),
always keep the earth wire longer than
the phase wires and, in addition, follow
all the instructions given in the “Electrical
connection” paragraph.
• To change the oven lamp see the instructions given
“Replacing the oven lamp” paragraph.
• To change the spark generator, the spark
electrodes and the lamp holder type 2 the work
top has to be removed as indicated in paragraph
“Replacing the taps”.
• To change the lamp-holder force the tabs of
blockage and take the lamp-holder toward the
inside of the oven.
• To change the eventual programming accessory,
the thermostat, commutators, the switchs and the
microswitchs, , remove the front panel as indicated
in paragraph “Replacing the taps”.