User manual

1
2
B
6. Pull the door trim to the front to remove
it.
7. Hold the door glass panel by its top
edge and carefully pull it out. Make sure
the glass slides out of the supports
completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
When the cleaning is completed, install the
glass panel and the oven door.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones is
not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal glass
panel in the seats correctly.
A
How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a cloth
to prevent grease residue from burning on
the lamp.
BEFORE YOU REPLACE THE LAMP:
Step 1 Step 2 Step 3
Turn off the oven. Wait until
the oven is cold.
Disconnect the oven from
the mains.
Put a cloth on the bottom of
the cavity.
Back lamp
Step 1
Turn the glass cover to remove it.
Step 2
Clean the glass cover.
Step 3
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4
Install the glass cover.
28
CARE AND CLEANING