Installation Instructions

6
30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
Four Conductor Wire Connection to Range
Where local codes does NOT permit connection of
the frame grounding conductor to the neutral wire
of the copper power supply cord (see Figure 9):
1. Remove the screws from the access plate at
the lower right end of the rear cover to expose
range terminal connection block.
2. Remove the grounding strap from the terminal
block and from the appliance frame.
3. Using the nuts supplied with the literature
package, connect the ground wire (green) of
the copper power supply cord to the frame of
the appliance with the ground screw, using the
hole in the frame where the ground strap was
removed (see Figure 9).
4. Connect the neutral of the copper power supply
cord to the center silver-colored terminal of
the terminal block, and connect the other
wires to the outer terminals. Match wires and
terminals by color (red wires connected to the
right terminal, black wires connected to the left
terminal).
5. Replace the terminal cover and replace the
screws.
Terminal Block
Silver Colored
Terminal
Red
Wire
Neutral
(White
Wire)
Ground (Bare
Copper Wire)
To 240 V
Receptacle
A User Supplied
Strain-relief Must
Be Installed at This
Location
Black
Wire
1 1/8" (2.9cm)
Dia. Direct
Connection
Hole.PunchOut
Knockout for
1 3/8" (3.5cm)
Dia. Cord Kit
Hole.
NOTE: Be sure to remove
the supplied grounding strap.
Figure 9
Three Conductor Wire Connection to Range
If local codes permit connection of the frame
grounding conductor to the neutral wire of the
copper power supply cord (see Figure 8):
1. Remove the screws from the access plate at
the lower right end of the rear cover to expose
range terminal connection block.
2. Using the nuts supplied in the literature
package, connect the neutral of the copper
power supply cord to the center silver-colored
terminal of the terminal block, and connect the
other wires to the outer terminals. Match wires
and terminals by color (red wires connected to
the right terminal, black wires connected to the
left terminal) (see Figure 8).
3. Replace the terminal cover and replace the
screws.
Figure 8
This appliance is manufactured
with the frame grounded by connection of a
grounding strap between the neutral power
supply terminal and the frame. If used in USA,
in a new branch circuit installation (1996 NEC),
mobile home or recreational vehicle, where
local code do not permit grounding through
neutral (white) wire or in Canada; remove the
grounding strap from the frame and cut the
other end, near the neutral terminal. Connect
the appliance in usual manner.
Silver Colored
Terminal
1 1/8" (2.9 cm)
Dia. Direct
ConnectionHole.
Punch Out Knockout
for 1 3/8" (3.5 cm)
Dia.CordKitHole.
To 240 V
Receptacle
A User Supplied
Strain-relief Must
Be Installed at This
Location.
Black
Wire
Terminal
Block
Grounding
Strap
Red
Wire
Cord
Mounting
Plate
Neutral
(White Wire)