Complete Owner's Guide



NOTE

Both left front and rear elements must be OFF before

activating the bridge element. Bridge element will

only operate by using the front left control knob. The

left rear knob cannot be used while in bridge mode.

The cooktop will triple beep and the display will ash

until the left rear knob is turned OFF if the cooktop is

already in bridge mode.

Turning on the front left knob to activate the bridge

element while the left rear element is on will also cause

the cooktop to triple beep and the display will ash

until the left rear knob is turned OFF.

To Operate the Bridge Induction Element:

1. Place the correctly sized cookware on the induction

bridge surface element.

2. Push in and turn the control knob as shown in Figure

4 for larger or rectangular shaped cookware. The

“bridge” mark on the knob indicates that both front

and rear portions will heat.

3. Turn the knob to adjust the setting if needed. Start

most cooking operations on a higher setting and

then turn to a lower setting to nish cooking. Each

induction element provides a constant amount

of heat at each setting. Please note that not all

cookware will t the Bridge element correctly.

4. When cooking has completed, turn the surface

control knob to OFF before removing the cookware.

SETTING INDUCTION SURFACE CONTROLS

Figure 6

Front plus Rear

Figure 4

Front left control knob