FRIGIDAIRE iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_ _ Producl www,frigJ
This USE & CARE MANUAL instructed in this provides specific USE & CARE MANUAL. may occur. Common sense operating These and caution instructions instructions must be practiced are not when for your model. meant to cover installing, every operating, and possible air conditioner condition maintaining only as and situation that any appliance. For Your Safety The power supply cord with this air conditioner contains a current detection device designed to reduce the risk of fire.
CAUTION. I Avoid Injury o Provide units o occasional run ventilation during use. Do not direct or damage to the unit or other airflow at fireplaces heat related sources as this could cause flare ups or make excessively. Do not climb Do not hang on or place objects on outdoor objects off the unit. part of the unit. Do not place containers with liquids on the unit.
Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Normal Sounds High pitched Chatter Today's high efficiency compressors may have a high pitched chatter during the cooling cycle.
Air Conditioner ELECTRONIC Features CONTROL Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote.
Operating Instructions TO CHANGE TEMPERATURE temp/timer SETTING: YOU WILL SEE; 1 temp/timer auto aUtO [] hi DO THIS: reed lo [] hi reed lo PRESS A TO RAISE heat [] cool heat [] cool energy saver V TO LOWER fan omy energy saver #n on& Note: Tap or hold either up ( A ) or down ( V ) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 60 °F (16 °C) and 90 °F (32 °C) for cooling mode.
Operating Instructions (continued) TO USE THE ENERGY SAVER FEATURE; YOU WILL SEE; temp/timer temp/timer au_o [] hi DO THIS: reed [o PRESS MODE BUTTON heat cool [] energy saver /a, on_ CHOOSE ENERGY SAVER Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on.
YOU WILL SEE: temp/timer DO THIS: PRESS FILTER RESET BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off. REMOTE SENSING (on some models): FEATURE LIGHT pulsing ( On & Off intermittently ). _ o o temp/timer \ z , ,\ TEHP/TIM£R T£MP/TIHER 2 [2 o,6 sleep afUtnO imer [2 [
Operating Instructions (continued) FAULT CODES: temp/timer temp/timer auto temp/timer auto auto [] hi med to [] hi reed b [] heat med [] heat cool cool energy [] hi to remote sensing saver energy fan only [] heat cool remo_e sensmg saver /an o_ly /_n only % If the display reads "HS", a sensor has failed. Contact your Authorized Frigidaire Service Center. TO CHANGE TEMPERATURE remote sensing energy saver % If the display reads "AS", a sensor has failed.
Operating Instructions (continued) 4-Way Air Directional Louvers The 4-Way air directional louvers allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. To adjust the air directional louvers side-to-side, use the center handle as you move it side-to-side. (4-WAY) Care and Cleaning Clean your air conditioner occasionally to keep it looking new.
Before calling forservice, reviewthislist.It maysaveyoutimeandexpense. Thislistincludes common occurrences thatarenot theresultofdefective workmanship ormaterials inthisappliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug Current Device Tripped. Press the RESET button. House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker. Control is OFF.
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
