User manual

Choosing the location
Place the refrigerator close to a
grounded outlet. Do not use any
adaptor or extension.
Install the refrigerator in a well-
ventilated area, away from direct
sunlight and from heat sources, such
as ovens and burners, from
inflammable materials, and from
areas where water is frequently used,
such as sinks.
For a better performance, install the
refrigerator in a room with
temperature between 10ºF to 110ºF.
The freezer was designed to keep it
intern temperature between this
range.
In order to ensure that heat
dissipates rapidly and that the
refrigerator operates efficiently, with
low energy consumption, we
recommend leaving the following
minimum distances between the
refrigerator and the walls and ceiling:
Top: 30cm
Sides: 7,5cm
Back: 10cm
Check to be sure that there is
enough space in front of the
refrigerator to open the door (160°).
The exterior walls can warm up due
to the compressor and transfer the
temperature inside. So you can feel
temperature 30ºF higher than the
room temperature. For this reason it
is important keep enough space
around the refrigerator to allow air
circulation.
to
Do not install the refrigerator
outdoors.
Leveling the refrigerator
Install the refrigerator on a completely
level and solid surface. The door must
be closed when leveling the
refrigerator
Use a level with glass-enclosed
bubble to verify whether the
refrigerator is properly leveled, with
the four feet firmly on the floor.
If the refrigerator needs to be
adjusted, carefully lean it and turn the
front adjustable leveling feet until it is
firmly installed.
Proper leveling prevents movement,
vibration and other problems.
Do not substitute the original
refrigerator feet.
Wait at least 2 hours before plugging
the refrigerator in this will prevent
operating problems.
To Level Your Refrigerator:
After discarding crating screws and
wood base, use a carpenter’s level to
level the refrigerator from front-to-
back. Adjust the plastic leveling feet in
front, ½ bubble higher, so that the
door closes easily when left halfway
open.
Electrical installation
Before turning on the refrigerator,
check to see if the voltage of the
outlet to be used is the same as that
indicated on the tag located close to
the plug (along the power cord) or on
the refrigerator's identification label.
Installation
30cm
(top)
10cm
(back)
7,5cm
(side)
7,5cm
(side)
ENG
ENG
31
32