Specification Guide

INSTALLATION SPECIFICATIONS
Product Shipping Weight (approx.) – 46 Lbs.
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC
only electrical supply with ground required on separate circuit fused on
both sides of line.
Connected Load (kW Rating) @ 240 / 208 Volts = 7.2 / 6.2 kW
Amps @ 240 / 208 Volts = 35.0 / 35.1 Amps
Recommended Circuit Breaker – 30 Amps
Always consult local and national electric codes.
Cooktop cutout height includes clearance needed beneath cooktop to allow
for armored cable and installation of junction box on back wall. Position center
of junction box 10" inward from right side of cooktop cutout, and 12" down
from underside of countertop.
Overhead cabinetry should not exceed a 13" maximum depth.
Absolute minimum horizontal distance between overhead cabinets installed to
either side of appliance must be no less than 30".
Allow 30" minimum clearance between top of cooktop platform and bottom
of unprotected wood or metal overhead cabinet; or 24" minimum clearance
when bottom of wood or metal overhead cabinet is protected by not less than
1/8" flame-retardant millboard covered with not less than No. 28 MGS sheet
steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper.
Allow 1-1/2" minimum clearance between rear edge of cutout and nearest
combustible surface (or backsplash) above countertop.
Allow 2" minimum required clearance from left edge of cooktop to nearest
combustible wall and 2" minimum from right edge of cooktop to nearest
combustible wall.
Installation of drawer not recommended beneath cooktop.
To reduce risk of fire when using overhead cabinetry, install range hood that
projects horizontally a recommended minimum of 5" beyond bottom of
cabinets.
Induction Built-In Cooktop model FGIC3066T is approved to be used over any
Frigidaire® Electric Single Wall Oven. (Refer to Electric Cooktop Installation
Over 30" / 27" Electric Single Wall Oven Specifications page on web.)
OPTIONAL ACCESSORIES
Granite Countertop Installation Kit – (PN # 903061-9010).
Specifications subject to change. Accessories information available on the web at frigidaire.com / frigidaire.ca
Note: For planning purposes only. Always consult local and national electric, gas and plumbing codes.
Refer to Product Installation Guide for detailed installation instructions on the web at frigidaire.com / frigidaire.ca.
USA
10200 David Taylor Drive
Charlotte, NC 28262
1-800-FRIGIDAIRE
frigidaire.com
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
1-800-265-8352
frigidaire.ca
FGIC3066T 10/17
© 2017 Electrolux Home Products, Inc.
Drop-In Induction / Electric Cooktops
(Callouts MUST be charted per individual model).
Professional / Gallery / Baseline
13"
max.
cabinet
depth
18"
min.
30"min.
for
unprotected
cabinet
24" min.
for
protected
cabinet
K
A
B
C
* Includes clearance needed
beneath cooktop to allow for
armored cable and installation
of junction box on back wall
(
J
)
min. from
edge of cutout to front
edge of countertop
25"
min.
24"
E
Plywood base
(optional)
F
*
(
G
) min. between rear edge of cutout
and nearest combustible surface
(or backsplash) above countertop
4"x 8" opening to route armored
cable if base is present
D
(
H
)
min.
from left edge
of cooktop to nearest
combustible wall
H
(
I
)
min.
from right
edge of
cooktop to
nearest
combustible
wall
I
FGIC3066TB
BUILT-IN COOKTOP
30" INDUCTION
PRODUCT DIMENSIONS
A - Width 30-3/4"
B - Depth 21-1/2"
C - Height 4-3/8"
CUTOUT DIMENSIONS
D - Width (Min.)
 (Max.)
28-1/2"
29-7/8"
E - Depth (Min.)
(Max.)
19-5/8"
20-1/2"
F - Height (Min.)* 4-1/2"
REQUIRED CLEARANCES
G - (Min.) 1-1/2"
H - (Min.) 2"
I - (Min.) 2"
J - (Min.) 2-1/2"
K -  Cabinet
Opening
Width (Min.)
30"
UTILITY CONNECTION
LOCATIONS
Power Supply
Right
Rear