Owner Manual

ManualsBrandsFrigidaire ManualsKitchen Appliance PackageFrigidaire FRRERADWMW12002

BEFORE SETTING SURFACE CONTROLS

Assembly of the Burner Caps

Make sure that all of the surface burner caps and

surface burner grates are installed correctly and at

the correct locations.

1. Remove all packing material from the cooktop

area.

2. Make sure burner caps are properly placed on

the surface burners.

The burner head has a hole which ﬁts over the

ignitior. Make sure the head ﬁts sugly before

placing the burner caps.

Unpack the burner grates and position them on

the cooktop after the burner heads and caps are

properly installed.

On round-style burners, the burner cap lip (Figure

3) should ﬁt snug into the center of the burner

head and rest level. Refer to Figure 4 for correct

and incorrect burner cap placement.

Figure 4: Cap placement

CAUTION

• Do not allow spills, food, cleaning agents, or

any other material to enter the gas oriﬁce

holder opening.

• Always keep the burner caps and burner

heads in place whenever the surface burners

are in use.

• Never place ﬂammable items on the cooktop.

Once in place, you may check the ﬁt by gently slid-

ing the burner cap from side to side (Figure 3) to

be sure it is centered and ﬁrmly seated. When the

burner cap lip makes contact inside the center of

the burner head you will be able to hear the burner

cap click

Figure 5: Gently move cap for proper placement

IMPORTANT

Please note that the burner cap should not move

o the center of the burner head when sliding

from side to side.

• Do not use the surface burners without the

burner caps properly installed. Improperly

seated burner caps may prevent burners from

lighting or cause uneven ﬂame and heating.

• Missing pieces or improper installation may

lead to spills, burns, or damage to your range

and cookware.

• Never place ﬂammable items on the cooktop.

Figure 3: Burner cap (A) burner head (B) ignitor