User Guide

27
BEFORE YOU CALL
Visit our web site at
www.frigidaire.com
1-800-944-9044 (United States)
1-800-265-8352 (Canada)
CONCERN CAUSE SOLUTION
AUTOMATIC ICE MAKER
Ice maker is
not making any
ice.
Ice maker wire signal arm is
in the “up” or OFF position.
Ice maker has small cube
caught in mechanism.
Saddle valve on cold
water pipe is clogged
or restricted by foreign
material.
Move wire signal arm to the “down” or ON
position (side mounted).
Remove small cube from ice maker. The
iceandwaterltercartridgemaybe
clogged.Replaceltercartridge.
Turn off household water line valve.
Remove valve. Ensure that valve is not
a self-piercing saddle valve. Clean valve.
Replace valve if necessary.
Ice maker is
not making
enough ice.
Ice maker is producing
less ice than you expect.
Check to see if water
dispenser is dispensing
slower than normal.
Freezer control is set too
warm.
Side mounted ice maker should produce 4
to4.5pounds(approximately4quarts)of
ice every 24 hours.
Ifitis,replacetheiceandwaterlter
cartridge.
Set freezer control to colder setting to im-
prove performance of the ice maker. Allow
24 hours for temperature to stabilize.
Ice maker will
not stop mak-
ing ice.
Ice maker wire signal arm
is being held down by
some item in the freezer.
Move item and release wire signal arm.
Remove any ice cubes that are frozen
together over the wire signal arm.
Ice cubes are
freezing to-
gether.
Ice cubes are not being
usedfrequentlyenough.
Ice cubes are hollow
(partially frozen cubes
with water inside).
Freezer control is set too
warm.
Remove ice container and discard ice from
container. Ice maker will produce fresh supply.
Theiceandwaterltercartridgemaybe
clogged.Replaceltercartridge.
Set freezer control to colder setting. Allow
24 hours for temperature to stabilize.
DISPENSER (Ice & Water)
Dispenser will
not dispense
ice.
Dispenser lock out is
engaged.
There is no ice in the bin
to be dispensed.
The refrigerator doors are
not completely closed.
Dispenser paddle has
been pressed too long
and the dispenser motor
has overheated.
Press and hold control lock for three
seconds.
See the “Ice maker is not making any ice”
section above.
Be sure the refrigerator doors are com-
pletely closed.
The motor overload protector will reset in
about three minutes and then ice can be
dispensed.
Ice dispenser is
jammed.
Ice has melted and
frozen around auger
duetoinfrequentuse,
temperatureuctuations,
and/or power outages.
Ice cubes are jammed
between ice maker and
back of ice container.
Remove ice container, thaw, and empty
the contents. Clean container, wipe dry,
and replace in proper position. When new
ice is made, dispenser should operate.
Remove ice cubes that are jamming the
dispenser.