Quick Start Guide

Getting started
with your
side-by-side
refrigerator
Before you start
Before starting the refrigerator
Remove tape and glue residue from surfaces before turning on the refrigerator. Choose a place that
is near a grounded electrical outlet, allowing for clearances for ease of installation, proper circulation,
and plumbing and electrical connections. After you remove all of the package materials, clean the
inside of your refrigerator before using it. See CARE AND CLEANING in your Use & Care Manual.
Set your controls
Adjusting the refrigerator control will change the temperature in both compartments. The freezer
control can be left at the factory preset (*Recommended) or adjusted as desired.
To maintain temperatures, a fan circulates air in the refrigerator and freezer compartments. For good
circulation, do not block cold air vents with food items.
You’re in control
Your controls
Using your refrigerator starts with just adjusting your controls. Adjust the control in small increments,
allowing the temperature to stabilize.
In-Door User InterfaceFront of Door Control
Ice Maker
Hold 3 Sec
Active
Mode View
Inactive
Mode View
Sleep
Mode View
Your display is equipped
with a sleep and inactive
mode to prevent
accidental changes to
the unit settings when
you open or close the
doors. When both doors
are closed, the display
will be in sleep mode.
When either door is
first opened, the display
will be in inactive mode
where all the current
settings are visible
but dimmed.
Pressing any button on
the display will activate
the display and a tone
will be played. All
settings will then be
fully lit. Touch the
display again to change
any setting.
If there is no button
pressed for 10 seconds
while any door is open,
the display will default
back to inactive mode.
Cube Press the Cube button to get cubed ice.
Crush Press the Crush button to get crushed ice.
Light
Press the light button to turn on the dispenser light.
Ice
Maker
Press and hold the Ice Maker button for 3 seconds to
turn on the ice maker. When the Ice Maker LED is on,
the ice maker is on.
Water
To operate the water dispenser, press a glass against
the Water dispensing paddle. Dispensed water is not
cold. For colder water, add crushed ice or cubes before
dispensing water.
Water
Filter
Status
When you need to order a new water filter, the side
door UI will change to the Order status. When you
need to replace the water filter, the in-door control will
change to the red replace status and the front of door
control will display Replace Water Filter.
Air
Filter
Status*
When you need to order a new air filter, the Side Door
UI will change to the Order status. When you need to
replace the air filter, the in-door control will change to
the red Replace status and the front of door control
will display Replace Air Filter.
*Only on some models
A19937202 (2206)