Owner Manual

33
BEFORE CALLING
Concern Potential Cause Common Solution
Water/Moisture/Frost Inside Refrigerator
Moisture
collects on
inside of
refrigerator
walls.
• Weather is hot and humid.
• Flipper mullion
• The rate of frost buildup and internal
sweating increases.
• Adjust ipper mullion. (See “To adjust
the ipper mullion” in the Installation
section.)
Water collects
on bottom
side of drawer
cover.
• Vegetables contain and
give off moisture.
• It is not unusual to have moisture on the
bottom side of the cover.
• Both crispers contain an automatic
humidity control, which should adjust
automatically to the varying levels of
moisture inside the drawer without
creating additional condensation or
drying out the air inside the crisper
drawer, works with various types of
produce. If excess moisture is noticed,
check to verify humidity membrane is
not damaged and replace as necessary.
Water collects
in bottom of
drawer.
• Washed vegetables and
fruit drain while in the
drawer.
• Dry items before putting them in the
drawer. Water collecting in bottom of
drawer is normal.
Water/Moisture/Frost Outside Refrigerator
Moisture
collects on
outside of
refrigerator
or between
doors.
• Weather is humid. • This is normal in humid weather. When
humidity is lower, the moisture should
disappear.
Food/Drinks in Fresh Food Compartment/Custom-Flex Drawer
Food is
freezing.
• Temperature setting is too
low.
• Temperature sensor is
covered by food (right side
of fresh food area).
• Food is covering the air
ports.
• Move the setting to a higher degree.
• Allow space for air ow to the sensor.
• Allow space between the air ports and
the food.
Cold Drink Timer
Drinks are
freezing.
• Temperature setting is too
low.
• Cold drink timer is set too
long.
• Move temperature setting higher.
• Reduce time of cold drink timer
accordingly.