Complete Owner's Guide

42
SETTING OVEN CONTROLS
Steam Clean
The Steam Clean feature oers a chemical free and
time saving method to assist in the routine clean-
ing of small and light soils. For heavier baked on
soils use the Self Clean feature.
Figure 10: Add 1 cup of water
Be sure the oven is level and cool before starting
Steam Clean. If the oven temperature is above
room temperature a triple beep will be heard and
the function will not start. Steam Clean produces
best results when started with a cool oven.
To set a Steam Clean cycle:
1. Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from
the oven bottom.
3. Pour 1 cup of tap water onto the oven bottom.
Close oven door.
CAUTION
Do not add bleach, ammonia, oven cleaner, or
any other abrasive household cleaners to the wa-
ter used for Steam Clean.
Before cleaning any part of the oven, be sure all
controls are turned o and the oven is cool. The
oven may be hot and can cause burns.
Setting Delay Start Self Clean
To start a delay self clean with default clean time
of 3 hours.
1. Press ON/OFF key and touch Oven Modes.
2. Scroll and touch Delay Start.
If it becomes necessary to stop self clean when
active:
• Press OFF.
• If self clean has heated the oven to a high
temperature, allow enough time for the oven to
cool.
• Before restarting self clean, be sure to read
important notes below.
3. Touch NEXT and scroll Oven Modes to Self
Clean. Follow the information on the screen to
set delay time, self clean time.
Important notes
• If self clean was active and then interrupted by
a power failure or canceled before the oven was
thoroughly cleaned, it may be necessary to run
another self clean cycle.
• If the oven temperature was high enough when
self clean was interrupted the oven control may
not allow another self clean cycle to be set for
up to 4 hours.