Complete Owner's Guide

43
SETTING OVEN CONTROLS
Notes:
• Opening the oven door during the steam clean
cycle prevents the water from reaching the
temperature needed to clean.
• For best results, clean oven immediately after
the cycle is complete. Steam clean works best
for soils on the oven bottom.
• A non-abrasive scouring pad, stainless steel
sponge, plastic scraper, or eraser style cleaning
pad (without cleaner) can be used for dicult
soils. Moisten pads with water before use.
• Place a paper towel or cloth in front of the
oven to capture any water that may spill while
wiping out.
• Do not leave the residual water in the oven for
any length of time.
• Some condensation or water vapor may appear
close to the oven vent and the oven door glass.
This is normal. The oven gasket may become
damp; do not wipe dry.
• Local water sources often contain minerals
(hard water). If hard water deposits occur, wipe
cavity with a 50/50 solution of water and vine-
gar or 50/50 solution of lemon juice and water.
• Steam clean cannot be programmed with a
delayed start time.
• If Steam Clean results are not satisfactory, run a
Self Clean. See “Self Clean” on page 40.
4. Touch Oven Modes,scroll to and touch Steam
Clean.
5. Touch START.
6. The time the Steam Clean cycle will end is
shown in the display. Do not open the door
during this time. If door is open while in Steam
Clean (d-O) will appear in the display.
7. When the steam clean cycle is complete an
alert will sound and the O message will show
in the display. Press o to return to the clock.
8. Take care opening the door when the steam
clean is finished. Stand to the side of the oven
out of the way of escaping vapor.
9. Wipe oven cavity and bottom. Do not clean
oven door gasket (Figure 8). Avoid leaning or
resting on the oven door glass while cleaning
cavity.
Figure 11: Clean around the oven door gasket