Instruction Manual

ManualsBrandsFrigidaire ManualsCooking AppliancesFRIGIDAIRE GCWS2438A Wall Ovens Cooking Appliances

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

Figure 1

24" Single Wall Ovens

809017903 Rev A

English – pages 1-9

All dimensions are in inches (cm).

NOTES:

1. Allow at least 21" (53.3 cm) clearance in front of

oven for door depth when it is open.

2. Dimension G (cutout depth) is critical to the

proper installation of the built-in oven. If the oven

trim does not butt against the cabinet, or if noise

is heard on convection models, verify dimension G

to assure it is the required depth.

Printed in Thailand

FOR YOUR SAFETY: Do not store or use gasoline or other

ﬂammable vapors and liquids in the vicinity of this or any other appliance.

PRODUCT DIMENSIONS

A B C D E

23 1/2 (59.6 cm) 28 5/8 (72.7 cm) 21 7/8 (55.5 cm) 22 3/4 (57.9 cm)

28 1/4 (71.8

cm)

CUTOUT DIMENSIONS AND CABINET WIDTH

F G H. Standard Height

(**Others, see note 3)

Min. Max. Min. Min. Max.

22 (55.8 cm) 22 1/2 (57.2 cm) 23 1/2 (59.7 cm)

28 1/4(71.8

cm)

28 7/8

(73.3 cm)

24 (61 cm) Min

WALL OVEN INSTALLATION

3. For a cutout height greater than the minimum (H),

add one 2 "(5 mm) wide wood shim of appropriate

height to each side of the opening under the appli-

ance side rails.

4. If the cabinet cutout is more than the minimum

dimension, the oven trim must be installed.

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED

INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Hole for Cord

Electrical Junction Box

2" (5 cm) Wide Wood Spacer if Needed

oor Open

(see note 1)

is 31" (78.7cm).

Minimum required distance is

½" (11.4cm).

2”

(5 cm)

Min.

31”*

(78.7 cm)

)

3”

(7.6 cm)

2 1/8 ” (5.4 cm)

Min.

DO NOT COMBINE WITH COOKTOP. DO NOT INSTALL UNDER COUNTERTOP

Your new wall oven has been designed to ﬁt a variety of cutout sizes to make the job of installing

easier. The ﬁrst step of your installation should be to measure your current cutout dimensions and

compare them to the cutout dimensions chart below for your model. You may ﬁnd little or no cabinet

work being necessary.

United States

Summary of content (9 pages)

PAGE 1
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS United States INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Your new wall oven has been designed to fit a variety of cutout sizes to make the job of installing easier.
PAGE 2
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS CARPENTRY and SUPPORT Refer to Figure 1 for the dimensions of your appliance and the cabinet cutouts and space needed to fit the oven. The oven support or base surface must be solid plywood, solid wood, or a material verified to meet the temperature and strength requirements needed for your installation. No fiberboard, laminated/ coated wood or other material should be used that is not verified to meet temperature and strength requirements.
PAGE 3
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Electrical Requirements Read all instructions contained in these installation instructions before installing the wall oven. 2. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Remove oven door to facilitate installation.
PAGE 4
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 2. 3. 2. Electrical connection These appliances should be connected to the fused disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed cable. The flexible armored cable extending from the appliance should be connected directly to the junction box.
PAGE 5
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS NOTE TO ELECTRICIAN: The armored cable leads supplied with the appliance are UL-recognized for connection to larger gauge household wiring. The insulation of the leads is rated at temperatures much higher than temperature rating of household wiring. The current carrying capacity of the conductor is governed by the temperature rating of the insulation around the wire, rather than the wire gauge alone.
PAGE 6
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS NOTE: The shims are not included to make the shims as needed depending on the size of existing cut-out. Top of the shims to top of the cabinet opening should be 37 1/2 in. 3. Cabinet Installation IMPORTANT! You must install the trim kit and/or the shims before placing your oven in the cabinet. You will not be able to install the trims kit and/or the shims after the oven has been installed.
PAGE 7
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 4. Installing Conduit Cable 1. 2. 3. 4. 5. 6. Remove two screws at the top of the Terminal Block cover using Phillips head screwdriver. Remove four screws on conduit cover using a Phillips head screwdriver. Put conduit cable through the opening of the panel (A). Attach conduit cable to terminal block in accordance to the corresponding color order (See figure 8) by removing the inteded screw, slipping the wire onto screw and rescrewing it back into position.
PAGE 8
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 5. Install the Anti-tip Mounting Screws IMPORTANT! Do not lift or manipulate the oven by the door handle or the control panel. The wall oven can tip when the door is open. The anti-tip mounting screws supplied with the wall oven must be installed to prevent tipping of the wall oven and injury to persons. Electrical Shock Hazard • • A. Locate the appliance mounting screw holes (see figure 12). Use 2 or more people to move and install wall oven.
PAGE 9
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 6. Leveling the Wall Oven 7. Checking Operation 1. Install an oven rack in the center of the oven (see Figure 13). Place a level on the rack. Take two readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level if necessary. Your model is equipped with an Electronic Oven Control. Each of the functions has been factory checked before shipping.