Instruction Manual

7
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
4. Installing Conduit Cable
1. Remove two screws at the top of the Terminal Block
cover using Phillips head screwdriver.
2. Remove four screws on conduit cover using a Phil-
lips head screwdriver.
3. Put conduit cable through the opening of the panel
(A).
4. Attach conduit cable to terminal block in accor-
dance to the corresponding color order (See figure
8) by removing the inteded screw, slipping the wire
onto screw and rescrewing it back into position.
5. Return conduit cover to original position and screw
the panel back in.
6. Place the cable in the groove (see fig.10) before se-
curing the clamp over the cable and screw back in.
Figure 10
Conduit Installed and Secured
Figure 8
Conduit Location and Cover
A
Red
Black
White
Green
Figure 9
Terminal Block Installation