Use & Care Guide

Remote Control

Operating Instructions

Battery Installation and Important Instructions

Remove the cover at the back of the remote control.

Insert the provided batteries correctly(see the instructions

inside the battery compartment).

Close up the cover.

To replace the old batteries(which have been used up)

with two new R03 “AAA” 1.5V batteries, repeat the

steps above.

Fan Speed Display

Fan Speed Button

On/Off Button

Temp Setting Display

Sending Signal

Temp Setting Button

If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in

accordance with local legislation as they do harm to the environment.

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

Do not dispose of batteries in fire. Batteries may explode or leak. If the remote control is not used for a

long time, remove the batteries from the remote control.

The remote control must be handled with extreme care. Do no

t drop it or expose it to direct sunlight

or sources of heat.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Point the remote control at the location of the signal receiver.

The remote control must be no more than 16 ft(5 meters)

away from the unit (without obstacles between the remote

Fig.17

User

Remote Control

Portable AC

Fig.18

control and the unit).

