Use & Care Guide

Plug in the unit, then press the “ ” button (when turned on, the unit will operate as the last setting

before shutdown.

To switch the unit off, press “ ” button again, then remove the plug.

Do NOT switch the unit off by removing the plug.

Always switch the unit off by pressing the “ ” button and wait for few minutes before removing the plug.

During Auto, Cool or Fan mode, press the “ ” button to select the desired fan speed. As show below.

During Auto or Cool mode, press the

“ í ” to decrease the set temperature

by 1 ºF or press the “ + ” button to increase the set temperature by 1 ºF.

The set temperature can be change in a range of 60 ºF to 90 ºF.

How to Use the Remote Control

TURNING THE UNIT ON

Change fan speed setting

Operating Instructions

Low Med Hi Auto

Change temperature setting

Press the “ í ” and “ + ” button the same time for more than 3 seconds to switch

between degree Fahrenheit and degrees Celsius.

Note: Under Dry/Fan mode, you can not select C.

°F/°C function

Fault Code

If the screen on the unit displays “P1”, the water

collection tank inside the unit should be full.

Refer to the "Drainage Instructions" on Page

15 for more instructions to drain the

successive condensate. If error repeats,

contact your Authorize Frigidaire Service Center.

If the screen on the unit displays

“ES”, the pipe temperature sensor

has failed. Contact your Authorize

Frigidaire Service Center.

If the screen on the unit displays

“AS”, the room temperature sensor

has failed. Contact your Authorize

Frigidaire Service Center.

If the di

splay reads "E4" , the communication

between display PCB and main control PCB

is faulty. Contact your Authorized Frigidaire

Service Center.

