Operation Manual

Choosing Centigrade or Fahrenheit (Select Models)
Depending on which temperature standard you prefer to use, you
can set your control panel to display in Centigrade or Fahrenheit. To
change between these standards, press the Mode button.
Making Temperature Adjustments
After running your refrigerator for 24 hours, you can adjust
temperatures as needed. Make your adjustments small and gradual,
allowing time for temperatures to change and stabilize. Refer the
following guidelines for temperature settings.
Temperature Control Range
Freezer Refrigerator
°F °C °F °C
Warmest 6° -14° 47° 8°
Less Cold
Factory
Setting
Midpoint 0° -18° 37° 3°
Colder
Coldest -10° -23° 33° 1°
Temperature Adjustment Guide
If Refrigerator compartment
is too warm
Adjust Refrigerator control one degree
colder by pressing the Down arrow button.
If Refrigerator compartment
is too cold
Adjust Refrigerator control one degree
warmer by pressing the Up arrow button.
If Freezer compartment is
too warm
A
djust Freezer control one degree colder by
pressing the Down arrow button.
If Freezer compartment is
too cold
A
djust Freezer control one degree colder by
pressing the Up arrow button.
What To Do If The Temperature Displays Flash
If ever you see the temperature displays continuously flashing, it
may indicate that the control system has detected a performance
problem. Call your service representative, who can interpret the
flashing message.
System Monitoring Alarms (Select Models)
The electronic control system continuously monitors your
refrigerator/freezer for temperature consistency, doors left ajar, and
power failures. Variances from normal operating conditions are
communicated by audible tones and a set of four status indicator
lights.
Note
Each time you make settings on the control panel, a single
audible tone acknowledges your input.
Responding to Alarms (Audible Tones & Indicator Lights)
Your refrigerator’s control system can convey the following
information through audible tones and the alarm indicator lights.
Alarm Light Tones Condition How To Respond
On (light is
off)
Alarm system is
not active while
freezer and
refrigerator
compartments
are cooling
toward the
current
temperature
settings.
If freezer and refrigerator
compartments do not
match your
temperature settings in
three hours, expect the
control system to signal
other conditions. If
cooling does not
stabilize toward your
current settings call for
assistance, using the
phone number on the
back page of this Use &
Care Guide.
Steady
Green
Alarm system is
active.
No response required.
Door
Ajar
Flashing
Green
9
Freezer or
refrigerator door
has been open
for over five
minutes.
Close door to disable and
reset alarm.
High
Temp
Flashing
Amber
9
Freezer or
refrigerator
compartment
has been too
warm (7.2° C or
higher) for over
an hour.
Press Alarm Reset button
to turn off alarm. If
temperatures do not
improve, call for
assistance, using the
phone number on the
back page of this Use &
Care Guide.
Power
Failure
Flashing
Amber
A power outage
was detected.
Press Alarm Reset button
to turn off alarm and
press again to reset.
Check if the power
failure lasted long
enough to affect stored
food temperatures.
6