user manual

6
INSTALLATION
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
Leveling Freezer Drawer (if necessary)
To level the cabinet using the front rollers
(select models):
1 Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
2 You can raise or lower each door. Use a
⅜
inch
socket wrench to turn the adjustment screws (one
per side).
1 Check gasket seal around top, bottom, and sides of
freezer drawer.
2 If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
3 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
4 Tighten four drawer screws.
5 Recheck gasket seal.
Push Against
Freezer Drawer
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
A B
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Raise
Lower
Anti-tip
Leg
Door
Door
5 Installthetoegrillebyttingintoplace.
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for nal positioning of your refrigerator:
• Allfourcornersofthecabinetmustrestrmlyon
theoor.
• The sides should tilt ¼ inch (6 mm) from front to
back (to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
3 Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
4 After unit is leveled, lower anti-tip leg until it
contactstheoor.
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.