Aftermarket Installation Information

Back of Cabinet Water Valve Installation Instructions

19. The water valve location has pre-made holes on the

right rear of the unit. The water line should be ori-

ented downward when the valve is installed. Install

the water valve using a ¼" hex head driver or drill,

install the 2 hex head screws (B). Tighten screws

until they are snug and then tighten an additional

¼" turn. See Figure 20.

Figure 20

18. Place the green water tube to the ice maker into

the bottom outlet of the water valve. Push the

tube into the valve up to the black line marked

on the tube. Lightly pull on the tube to make sure

you installed it correctly. See Figure 19.

Figure 19



NOTE

Connect the plastic water supply tubing and

the wiring harness to the water valve prior to

mounting the valve to the rear panel because

of space constraints.

17. Plug the connector on the supplied water valve

into the harness found in the bottom right of the

compressor compartment. See Figure 17.

Figure 18

Install the supplied clip into the compartment and

route the water valve harness through clip.

See Figure 18.

Figure 17