Manual

Operating Instructions

(continued)

6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours.

If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is

off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start).

TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the A or V button to

change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The

control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the

fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER

button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either

starts or stops. Once that happens the above steps have to be repeated.

1. Before entering TIMER setting, make sure power is being supplied to the unit.

2. Before entering TIMER setting, make sure pressing HUMIDITY A or V button sets one desired room humidity first.

bucket full

clean jSlter

fitter V A timer ON-OFF

Lhum_d_ty-j

law

fan

speed

7. To shut the unit down, press the ON/OFF button.

bucket,full

cleanj_lter low

i I

fitter fan

speed V A timer

Lhum_d_tyJ

ON=OFF

Fault Codes

1. If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center.

bucket fu!!

clean _lter

filter V A timer ON-OFF

Lhum_d_tyJ

law

fan

speed