Installation Instructions

EN-3

Illustration

ELECTRICAL OUTLET LOCATION

Outlet should NOT be in the shaded area as indicated

on Illustration 3

NOTE 1:

The floor of the opening should be constructed of

plywood strong enough to support the weight of the

oven and floor load (approximately 100 pounds). The

floor should be level for proper operation of the oven. Be

sure to check the local building code as it may require

that the opening be enclosed with side, ceiling and rear

partition. The proper functioning of the oven does not

require the enclosure.

Illustration

EXHAUST DUCT ASSEMBLY

1. Draw a Central Line on floor. Place the Exhaust

Duct in the opening，When the Exhaust Duct

Assembly is in the opening correctly, the Center

Line is in the middle of the Exhaust Duct

Assembly. See Illustration .

2. Secure the Exhaust Duct Assembly with the

three screws A.

IMPORTANT: Secure screws in outer hole.

3 are needed for exhaust duct assembly

Screw A

Center Line

pcs