Installation Guide

5
30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS
Fig. 11
5A. POWER CORD CONNECTIONS
(4-Wire Connection Instructions - Refer
to Fig.12)
Before wiring the range review the suggested power
source location drawing in Fig. 3. If connecting to a 4-Wire
electrical system (new branch-circuit or mobile home
requires 4-Wire connection):
1. Follow the manufacturer’s installation instructions
supplied with the strain relief and install (Also see Figs.
9, 10 & 11).
2. Insert the end connectors for Line 1, Line 2 and
Neutral and tighten securely to the terminal block.
IMPORTANT NOTE: DO NOT LOOSEN the factory
installed nut connections which secure the range
wiring to the terminal block. Electrical failure or loss
of electrical connection may occur if these 3 nuts are
loosened or removed.
3. You must disconnect the ground strap. Remove the
factory installed ground screw & plate to release the
copper ground strap from the frame of the appliance.
Cut and discard the copper ground strap & plate.
KEEP the ground screw.
4. Connect the ground wire (Green) lead with the eyelet
to the frame of the appliance with the ground screw
using the same hole in the frame where the ground
screw was originally installed (See Fig. 12).
5. Make sure all screws are tightened securely and
replace the rear access cover (See Fig. 9).
Fig. 12
NOTE: Internal
white wire not
present on all
models.
5B. POWER CORD CONNECTIONS
(3-Wire Connection Instructions
For existing installations ONLY - Refer
to Fig. 13).
1. Follow the manufacturer’s installation instructions
supplied with the strain relief and install (Also see
Figs. 9, 10 & 11).
2. Insert the end connectors for Line 1, Line 2 and
Neutral and tighten securely to the terminal block (See
Fig. 13).
IMPORTANT NOTE: DO NOT LOOSEN the factory
installed nut connections which secure the range
wiring to the terminal block. Electrical failure or loss
of electrical connection may occur if these 3 nuts are
loosened or removed.
3. Make sure all connections are tightened securely and
replace the rear access cover (See Fig. 9).
NOTE: Internal
white wire not
present on all
models.
Fig. 13
Fig. 10