Installation Guide

11
30” GAS FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS
16. Care, Cleaning and
Maintenance
Refer to the Use & Care Manual for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut o󰀨 gas supply. Disconnect the gas
and electrical supply. If the gas or electrical supply is
inaccessible, lift the range slightly at the front and pull out
away from the wall. Pull out only as far as necessary to
disconnect the gas and electrical supply. Finish removing
the range for servicing and cleaning. Reinstall in reverse
order making sure to level the range and check gas
connections for leaks. Be sure to read and follow step 1 for
proper Anti-tip installation.
Some models have a cold air intake vent at
the back of the unit. Do not cover this vent.
15. Install ller trim kit
Note: Installation of the ller trim kit is not required.
Disconnect electrical power to range before
beginning installation. Before servicing any part of the
appliance, make sure the appliance is o󰀨 and the surfaces
are cool. Attempting to service the appliance while hot may
cause burns or other injury.
Filler Trim Attachment Instructions:
1. Remove the 7 screws on the vent trim on the back.
Range with ller trim installed.
2. Place the ller trim over the back by lining up the 7
screw holes of the ller trim with the vent trim and
tighten screws.
3. When ller trim is secured it will be ush with the top of
the range.