Manual

PREPARE THE HOOD PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3_" x 10"
Vertical & for 7" Round
Discharge)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
ge)
UP TO 1"
SIDE-TO-SIDE
TAPE TOP/BACK
EDGE
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3_" x 10"
Horizontal Discharge)
r_ Remove Duct from back of
appropriate Knockout(s) top
or
hood.
TIES
SCREW
METAL STRIP PLATE
Horizontal Discharge Only: Remove the Plate in front of the
horizontal discharge knockout. Cut the Ties, lift plate out,
and discard plate. DO NOT REMOVE the Metal Strip held in
place with two Screws.
DAMPER/
DUCT
CONNECTOR
(Vertical discharge
position shown)
3%" x 10" Ducted Discharge Only: Remove Tape from
damper flap and attach Damper/Duct Connector over
knockout opening with screws removed in Step 4 under
"PREPARE THE HOOD". Make sure damper Pivot is nearest
to Top/Back Edge of hood.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD".
Install a 7" round damper (purchase separately). Damper flap
must open freely in direction of airflow (away from range
hood).
r.-_-_ To accomodate off-center ductwork the Damper/Duct
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed up to ½"
on either side of hood center. In extreme off-center installations,
one end of the duct connector may need to be trimmed to clear the
electrical cable clamp.
EDGE
[_ Non-Ducted Installations Only: Require a Performance Ring
to be attached to the blower wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side to side and
applying a slight force to pull wheel from motor. Remove
Retaining Ring if necessary.
2. Slide the ring onto the Small Diameter End of the wheel
and down to the Stop Edge of the wheel.
3. Reassemble wheel to motor. Make sure Tab on wheel fits
into one of the Motor Slots.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press
Sections into place if necessary. Make sure wheel turns freely.