Manual

Important Notes to the Installer
1, Read all instructions contained in these installation
instructions before installing appliance,
2, Remove all packing material from appliance before
connecting the electrical supply.
3, Observe all governing codes and ordinances.
4, Besure to leave these instructions with the consumer,
Important Note to the Consumer
Keep these instructions for future reference,
IMPORTANT SAFETY
INSTRUCTIONS
• Be sure your appliance is installed and plugged
into a 120 Volt grounded outlet.
• This appliance must be electrically grounded in
accordance with the National Electrical Code ANSI/
NFPA No. 70--latest edition in the United States,
or CSA C22.1, Part 1 in Canada, and local code
requirements.
Tools You Will Need
Phillips® Screwdriver
Pencil
Ruler or Tape Measure and Straight-edge
Hand Saw or Saber Saw
Spirit Level
Warm & Serve Drawer Installation
1,
Remove the 2 support brackets attached by 2 screws
to the top of drawer (see Figure 1), Discard these 2
screws. These brackets are required only if drawer is
to be combined with a 30"(76 cm) built-in oven
mounted above,
Go to step 2 if warmer drawer is installed under
a 30" (76 cm) electric wall oven.
If drawer is to be used as a stand alone drawer,
discard support brackets and go to step 3.
2,
Insert support bracket tabs in the locating slots on
top of warmer drawer, Use the 4 screws removed
from sides of warmer drawer to secure support
brackets to drawer housing (see Figure 1).
Mounting
Removebrackets
from this location
Fand install as shown.
1
/
Warm & Serve-
Drawer
Figure 1
Reuse4
mounting screws
10