Manual

NOTE: For stand-alone installation, the base must be 4,

capable of supporting 100 Ibs. (45 kg). For a

combination Warm & Serve Drawer and built-in oven

installation, the base must be capable of supporting 250 5,

Ibs. (114 kg),

Remove the 2 locking plates and 6 screws included

in literature package. Mount the locking plates on

each s_de of cabinet c pening a_ong ns_ae of cutout

as ShOWn ,, _ gure 2 Center ROle mus[ De 7-5/8

(19.4 cm from cutout DO[[Om ro _neup w_tn holes

n wa/mer drawer housln J Use the 2 black screws [o

fasteR each lOCKing [ ate to the cabinet

Appro_mately

5/16 (.8cm)

7-5/8"

(19.4 cm)

Use 2 screws to

attach each locking plate

to each side of cabinet <l_Locking

plate

Figure 2

Slide drawer into cutout opening until front frame of

drawer is flush against cabinet. Be careful not to

[)inch electrical cord,

Open drawer and secure housing to locking plates

using the 2 nickel-plated screws supplied, Drive

screws from inside drawer into middle hole in each

locking plate (see Figure 3). De not overtighten

screws.

attach Iocldngplates_ _- ! : .,

to draw_ housing .

Figure 3

The 60" (152 cm) appliance power cord can now be

connected into the 120 Volt outlet,

Proceed with mounting built-in oven above the

drawer (if applicable), Follow installation instructions

provided with built-in oven. Make sure to use anti-tip

brackets supplied with the built-in oven.

NOTE: Use a piece of cardboard to protect warmer

drawer frame and prevent scratching when installing

wall oven over warmer drawer,